Abstract:This paper compares several approaches to model the unsteady and nonlinear longitudinal aerodynamics of a generic unmanned combat air vehicle configuration based on computational fluid dynamics (CFD). Three different reduced-order models (ROMs) are implemented through unsteady simulations to predict the evolution of forces and moments during prescribed trajectories carried out at [Formula: see text]. The first model investigates a linear quasi-steady model based on a first-order Taylor series expansion of the aerodynamic coefficients. The second one picks up the mathematical formulation of the first model but adds a dynamic coefficient in order to take into account the unsteady effect of rotation rate variations. Finally, the third model is built on indicial functions computed from positive step changes in the angle of attack or pitch rate. The unknown parameters of the first two models and the unknown indicial functions of the third one are obtained, respectively, from the study of forced oscillations and step motions. These prescribed trajectories are performed using unsteady Reynolds-averaged Navier–Stokes simulations coupled with a grid displacement tool. Two different methods are tested and compared to carry out the CFD mesh motions: an overset method and a full moving grid (FMG) method. The indicial functions obtained using the FMG method give results equivalent to those found in the literature in half the time of the overset method. To reduce the computational costs to set up the ROMs, the FMG method is preferred to the overset method. ROMs are then applied, and their predictions are compared with CFD simulations for prescribed trajectories with different angular rates and angles of attack. A study of instantaneous and overall accuracy associated with the implementation cost of the ROMs has allowed to show their strengths and their weaknesses. Similar results are observed at low angles of attack for the ROMs studied, while a major modeling advantage of the indicial method has been identified for higher angles of attack in the nonlinear domain.

A CFD-Based Compositional Methodology of Unsteady Aerodynamic Modeling for Turbomachinery

Flow Computations of Multi-Stages by URANS and Flux Balanced Mixing Models

Flutter analysis of compressor blades under travelling wave modes using an efficient fluid-structure interaction method

Numerical Study on Stall Flutter of Axial Turbomachinery Blade Based on Fluid-Structure Coupling

A Combined Method of CFD Simulation and Modified Beddoes-Leishman Model to Predict the Dynamic Stall Characterizations of S809 Airfoil

Bleed air CFD modelling in aerodynamic simulation of A heavy duty gas turbine compressor

Coupled Fluid-structure Aeroelastic Analysis of Turbomachinery Using Conservative Data Transfer Algorithm

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine

A viscous blade body force model for computational fluid dynamics–based throughflow analysis of axial compressors

An Efficient Coupled-Mode Flutter Analysis Method for Turbomachinery

Analysis of an Airfoil's Flutter Control Technique of Blowing by a Fluid-Structure Coupling Method

A Simplified CFD Method to Partial Admission Fluid Force Estimation in Turbine

THREE DIMENSIONAL VISCOUS FLOW NUMERICAL ANALYSIS OF STALL FLUTTER IN STEAM TURBINE BLADES

Accuracy and Computational Cost Comparison of Numerical Flight Dynamics Reduced-Order Models

A novel unsteady aerodynamic Reduced-Order Modeling method for transonic aeroelastic optimization

Experimental and Numerical Quantification of the Aerodynamic Damping of a Turbine Blisk

CFD Simulation of the Unsteady Performance of Contra-Rotating Propellers

Aeromechanical Analysis of a Complete Wind Turbine Using Nonlinear Frequency Domain Solution Method

Full 3-D Viscous Aerodynamic Optimization Design System for Turbomachinery

Numerical Simulation of Aeroelastic Response in Compressor Based on Fluid-Structure Coupling

An Efficient Implementation of Transonic Aeroelastic Tailoring based on a Reduced-Order Model using Structural Dynamic Reanalysis Method