Abstract:With the increasing usages of high strength and lightweight materials, how to accurately predict and fully understand the wrinkling instability of thin-walled parts forming under various loading conditions, viz. stress states and normal constraints, is still a challenge for free-defect design and manufacturing. In this study, taking tension-compression stress state w/wo normal constraints (Yoshida test and deep drawing of sheets) and compression stress state w/wo normal constraints (axial compression and rotary draw bending of tubes) as the comparative cases, two kinds of geometric imperfections (GI), viz., random thickness imperfection (RTI) and geometric deflection imperfection (GDI) are introuduced and implemented into dynamic explicit finite element (FE) models to realize more sensitive prediction of the wrinkling instability. And then, a systematic comparative study on the critical wrinkling behavior and final wrinkling morphology under varous loading conditions has been studied. It is found that the wrinkling is more prone to occur under tension-compression stress state, and the wrinkling of the processes without normal constraint are severer than those with normal constraints. Furthermore, the effects of material parameters on the wrinkling are inconsistent in different processes, the reason proved to be the different loading conditions. When the degree of normal constraint increases, the influence of material properties becomes negligible. Combining the geometric and material parameters, the key issues affecting the wrinkling of thin-walled parts from the perspective of loading condition have been expounded, laying the foundation and theoretical guidance for the study of wrinkling behavior under different mechanical states.

Wrinkling and Instability Analysis of Thin-Wall Cylindrical Parts in Viscous Medium Outer Pressure Necking

Analysis of Deformation in Viscous Medium Outer Pressure Necking for Thin-Wall Parts with Variable Diameter Section

Viscous medium outer pressure necking forming and numerical simulation for thin-wall parts

Form of Circumferential Weld-Induced Imperfections for Tapered-Wall Cylindrical Shell Structures

Influences of Conditions at Tube-Blank End on Viscous Medium Outer Pressure Necking of Thin-Wall Parts

Mechanism and Controlling of Wrinkles During Hydroforming of Integral Thin-walled Curved Shell

Research on Forming Process and Deformation Rule for the Necking of Viscous Medium under Outer Pressures

Analysis of wrinkling during sheet hydroforming of curved surface shell considering reverse bulging effect

A New Method to Accurately Obtain Wrinkling Limit Diagram in Nc Bending Process of Thin-Walled Tube with Large Diameter under Different Loading Paths

Effect of boundary conditions of cylindrical shells on stabilisation of tube compression by viscous pressure forming

Analysis on Critical Conditions of Sidewall Wrinkling for Hydroforming of Thin-Walled Tee-Joint

Application and approaches of viscous medium inner pressure forming of thin-wall variable-diameter parts

A Study on Plastic Wrinkling in Thin-Walled Tube Bending Via an Energy-Based Wrinkling Prediction Model

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Forming Thin-Walled Circular Rings with Corrugated Meridians Via Quasi-Bulk Deformation of Metal Blank and Viscous Medium

The influence of length–diameter ratio in forming area on viscous outer pressure forming and limit diameter reduction

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Analysis of Plastic Wrinkling Behavior in Tube Hydroforming Process

Wrinkling Analysis for Forming Limit of Tube Bending Processes

WRINKLING BEHAVIOR IN HYDROFORMING OF UNSYMMETRICAL TUBULAR PART

Forming Characteristics of Thin-Walled Tube Bending Process with Small Bending Radius