Abstract:Gamma imager capable of monitoring, detection and localization of radioactive sources is of critical importance for nuclear safety and homeland security with the increasing use of radioactive sources in applications of nuclear technology. A 4π view gamma imager based on gamma ray occlusion technique is under development in our lab. The key component of the gamma imager is a 3D position-sensitive detector, which enables 4π field of view of the imager. In this work, we propose a 3D positionsensitive detector design for the 4π view gamma imager based on dual-ended readout (DER) technique. The detector was composed of a GAGG block coupled to an SiPM array at both crystal ends. DOI calibration was conducted with a collimated fan beam 18F source and DOI resolution was evaluated. Energy calibration was performed for each 3D position region of the detector by incorporating 3D position information to correct for the energy response inconsistency at different 3D position regions inside the detector. Various radioisotopes including 99mTc, 131I, 137Cs and 22Na were tested. An exponential factor was applied to compensate for energy response non-linearity due to SiPM saturation effect at higher gamma energy. The measured average DOI resolution was 1.96 ± 0.21 mm for all the four DER detector modules, indicating excellent 3D positioning accuracy of the detector design. With the proposed energy calibration approach, characteristic photopeaks of each radioisotope can be clearly identified at the correct energy position on the measured energy spectra. The achieved energy resolution was 9.76% at 662 keV, demonstrating good energy performance of the detector design, which could benefit radioisotope identification capability of the gamma imager. To conclude, the proposed 3D position-sensitive detector design based on DER technique features good 3D positioning and energy performance and is feasible for the 4π view gamma imager.

An Improved Gamma Scanning Technique Using Two Detectors at Off-Center Positions

An efficiency calibration method of segmented gamma scanning in reconstructing radioactive waste drum activity

A density correction method for radioactive waste drum based on SRGS technology

A SGS efficiency calibration method for measuring the radioactive waste drum based on Monte Carlo simulation and function model

Advanced Technique And Multi-W-Shaped Slit Gauge For Quantifying Spect Spatial Resolution Of Gamma Camera Scan Data: An Enhanced Study

Absolute Gamma Source Positioning with Position-sensitive Scintillation Detector Arrays

A new approach in the detection of weak γ-ray peak of the radioactive waste in tomography γ scanning

Sensitivity analysis of gamma spectroscopy system with dual high-purity germanium detectors

A Geometrical Correction Method For Radioactive Intensity Image Reconstruction In Tomographic Gamma Scanning

Noise Equivalent Counts Based Emission Image Reconstruction Algorithm of Tomographic Gamma Scanning

Experimental Validation of a Gamma Detector With a Novel Light-Guide-PMT Geometry to Reduce Dead Edge Effects

A Position Sensitive Scintillation Detector Using a Side-by-side GAGG-F/GAGG-T Phoswich Block

A New Method for Detecting Pulse Gamma Ray with Scattered Electrons

Image Reconstruction Based on Total Variation Minimization for Radioactive Wastes Tomographic Gamma Scanning From Sparse Projections

A study on the validation of a single-particle measurement system for leakage gamma-ray decay curves

A General Method For Optimizing The Parameter Of Alpha/Beta Discrimination In Liquid Scintillation Counting

An Ultra-Throughput Boost Method for Gamma-Ray Spectrometers

Study on the space resolution of a 2D-radiography system

Collimator-less 4π Gamma Imaging with 3-D Position-Sensitive Detector

Design and Development of a 3D Position-Sensitive Detector for 4π View Gamma Imager Based on Dual-Ended Readout Technique

A Maximum Likelihood Gamma Positioning Method with Accurate Calibration of the Mean Detector Response Function in a Clinical SPECT Detector