Abstract:This paper deals with high input voltage LED driver with a requirement of power factor correction (PFC). A series-connected metal-oxide-semiconductor field-effect transistors (MOSFETs) circuit which can support high total blocking voltage is proposed. Compared with the existing series-connected devices methods, this circuit can efficiently and reliably operate in a wide voltage range situation. Thus it can be applied in low cost flyback-based single-stage PFC ac/dc converter. In this circuit, the main switch is directly driven by the control IC while the slave switch is driven by an auxiliary circuit. The auxiliary circuit can also realize effective voltage sharing. The turn-on and turn-off operation principle is analyzed in detail. Then voltage stresses of the devices are derived, and the power losses of the auxiliary circuit are calculated, meanwhile a method of decreasing the voltage stress and power losses is given. Design guidelines are also provided in this paper. Experimental results basic on a 75W prototype show the proposed circuit works well with a 480Vac input.

Design of High-power Driver Circuit for DC Motor

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

Driver Circuit Suited for High Frequency Induction Heating

A MOSFET Drive Circuit Suitable for High-frequency Induction-heating Power Supply

Design of a Power Supply Module for Electric Vehicle Charging Station

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

A High-speed MOSFET Driving Circuit Design with Bridge Topology

A Low Power High Temperature Brushless DC Motor Driver

Design of Power MOSFET Driver Circuit for High Frequency Induction Heating Supply

A Design of PWM Driving Circuit for Ultrasonic Motor

High input voltage single-stage flyback AC/DC LED driver using series-connected MOSFETs

Design of Rail-to-Rail Output PWM Driving Circuit for DC Servo Motor

A High Power Buck Derived Non-Isolated Ac/Dc Led Driver

Power Loss Calculation for the Power Converter in Switched Reluctance Motor Drive.

Optimal Design of 5 kW PWM Plus Phase-shift Control Bidirectional DC/DC Converter

A High-Performance PWM Controller with Adjustable Current Limit

Research on Techniques of Three-level Six-phase Synchronous Motor Driver

Design of Control Drive Circuit for Two-phase High Power Step Motor

Design of the Inverter of High-Current Capability for PMSM under Low DC Voltage Supply

Design of a Dual Channel High Current Silicon Carbide MOSFET Driver

Research on the main circuit and control scheme of a new hybrid DC power supply equipment for motor drives