Abstract:Springback is one of the most important problems that should be compensated in sheet metal forming process with the increasing application of advanced high strength steels and light-weight alloys. In the finite element analyses for the springback, accurate modeling of Bauschinger effect, transient behavior and permanent softening under cyclic loading has been recognized as the most critical hardening behavior in the constitutive modeling aspect. However, if parts of these hardening behavior are not well modelled, is the accuracy of springback prediction seriously deteriorated? To answer this question, in this paper the significance of Bauschinger effect and transient behavior, permanent softening and unloading modulus in springback prediction were estimated using the springback problem of U-draw/bending simulations proposed at Numisheet2011 Benchmark. A recent anisotropic non-linear kinematic (ANK) model [Zang S, Guo C, Thuillier S, Lee M. A model of one-surface cyclic plasticity and its application to springback prediction. Int J Mech Sci 2011;53:425–35.] was adopted to estimate the significance of hardening behavior and unloading modulus because of its special feature. The ANK model can predict exactly the same monotonous stress–strain curves for different hardening schemes, while different Bauschinger effect and transient behavior under one-dimensional cyclic loading can be also modelled. This feature is quite suitable to quantitatively evaluate the effects of the aforementioned hardening behaviors in springback prediction. Initial anisotropy is described by the anisotropic yield function Yld2000-2d. The unloading behavior is also considered by defining Young's modulus as a function of equivalent plastic strain. Several quantitative analyses were carried out to distinguish the effect of each hardening component and unloading elastic modulus scheme. Finally, the predicted springback by different models were compared with experiments for both as-received and pre-strained DP780 steel sheets.

Effect of virtual kinetic energy on springback simulation accuracy

Study on Virtual Punch Velocity in Simulation of Sheet Metal Forming by Explicit Method

Analysis on the Effects of Numerical Simulation Precision on Springback Prediction

Study of the Influence of Element Size and Number of Integration Points on Accuracy of Sheet Springback Prediction

Adaptive multiple scale meshless simulation on springback analysis in sheet metal forming

An Analytical Model for Predicting Sheet Springback after V-bending

SPRINGBACK OF SHEET METAL AFTER PLANE STRAIN STRETCH-BENDING

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Size Effect Affected Springback in Micro/meso Scale Bending Process: Experiments and Numerical Modeling

THE SPRINGBACK OF WIDE METAL SHEET AFTER LARGE RADIUS PURE BENDING

Numerical Simulation of Microstamping Process to Fabricate Multi-channel of SUS304 Thin Sheets with Consideration of Grain Structures

Numerical Simulation of Springback of Force-displacement Separated Control Multi-point Forming for Sphere

An Analytical Model for Predicting Springback and Side Wall Curl of Sheet after U-bending

Study on Factors Affecting Springback and Application of Data Mining in Springback Analysis

Comparison of Material Models for Spring Back Prediction in an Automotive Panel Using Finite Element Method

The Numerical Simulation of U-channel Springback and Optimization of Forming Parameters

Eliminating Springback Error in U-Shaped Part Forming by Variable Blankholder Force

Influences of the Evolving Plastic Behavior of Sheet Metal on V-bending and Springback Analysis Considering Different Stress States

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

A Compensation Algorithm of Springback Error in Complex 3D Sheet Metal Forming and Experiment Validation