Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

THE SPRINGBACK OF WIDE METAL SHEET AFTER LARGE RADIUS PURE BENDING

SPRINGBACK OF SHEET METAL AFTER PLANE STRAIN STRETCH-BENDING

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

An Analytical Model for Predicting Springback and Side Wall Curl of Sheet after U-bending

Development of a new model for plane strain bending and springback analysis

Springback investigation of anisotropic aluminum alloy sheet with a mixed hardening rule and Barlat yield criteria in sheet metal forming

Sheet Springback Prediction Based on Non-Linear Combined Hardening Rule and Barlat89’s Yielding Function

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

An analytical model for bending and springback of bimetallic sheets

Mathematical modeling of plane-strain bending of sheet and plate

Springback Prediction Using the Split-Ring Test Based on A Combined Anisotropic Hardening Model

A Constitutive Model for Spring-Back Prediction in Which the Change of Young's Modulus with Plastic Deformation is Considered

An Analytical Model for Predicting Sheet Springback after V-bending

Springback prediction method for double-curved workpiece considering plate anisotropy in multi-point forming

An analytical and experimental study on springback behavior of sheet metals subjected to micro/meso scale bending based on the surface layer model

A Model of One-Surface Cyclic Plasticity and Its Application to Springback Prediction

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Springback Prediction Model Considering the Variable Young’s Modulus for the Bending Rectangular 3A21 Tube

Sheet metal forming limits under stretch-bending with anisotropic hardening

Springback prediction of stamping GH3536 alloy sheet with complex surface

Determining the Coefficients of a Homogeneous Anisotropic Hardening Model for Ultrathin Steel Sheets