Abstract:The most promising source of alumina in the 21st century is the coal fly ash (CFA) waste of coal-fired thermal plants. The methods of alumina extraction from CFA are often based on the pressure alkaline or acid leaching or preliminary roasting with different additives followed by water leaching. The efficiency of the alumina extraction from CFA under atmospheric pressure leaching is low due to the high content of acid-insoluble alumina phase mullite (3Al2O3·2SiO2). This research for the first time shows the possibility of mullite leaching under atmospheric pressure after preliminary desilication using high liquid to solid ratios (L:S ratio) and Na2O concentration. The analysis of the desilicated CFA (DCFA) chemical and phase composition before and after leaching has been carried out by inductively coupled plasma optical emission spectrometry (ICP-OES) and X-ray diffraction (XRD). The morphology and elemental composition of solid product particles has been carried out by scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDX). An automated neural network and a shrinking core model (SCM) were used to evaluate experimental data. The Al extraction efficiency from DCFA has been more than 84% at T = 120 °C, leaching time 60 min, the L/S ratio > 20, and concentration of Na2O-400 g L-1. The kinetics analysis by SCM has shown that the surface chemical reaction controls the leaching process rate at T < 110 °C, and, at T > 110 °C after 15 min of leaching, the process is limited by diffusion through the product layer, which can be represented by titanium compounds. According to the SEM-EDX analysis of the solid residue, the magnetite spheres and mullite acicular particles were the main phases that remained after NaOH leaching. The spheric agglomerates of mullite particles with non-porous surface have also been found.

Study on Extracting Alumina from Coal Ashes in the Coal-Fired Power Plant

Experimental Study of Extracting Alumina from Coal Fly Ash Using Fluidized Beds at High Temperature

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Effects of Sodium Carbonate and Sodium Chloride Additives on Alkaline Fusion of Coal Fly Ash

Dissolution of Alumina from Fly Ash Sintered Clinker

Experimental study on aluminum leaching of coal ash

Extraction of alumina from high-alumina fly ash by ammonium sulfate: roasting kinetics and mechanism

Extraction of alumina from high- alumina fly ash desilicated residue by Low- lime sintering process

Extraction of Aluminum from Coal Fly Ash Using Pressurized Sulfuric Acid Leaching with Emphasis on Optimization and Mechanism

Kinetics Study of Al Extraction from Desilicated Coal Fly Ash by NaOH at Atmospheric Pressure

Extraction of Aluminum Hydroxide from Coal Fly Ash by Pre-Desilication and Calcination Methods

An experimetal study on the alumina clinker as by-product through coal powder burning process

Mineral Conversion of Coal-ash in Fusing Process and the Influence to Ash Fusion Point

Experiments on the Effect of Chemical Components of Coal Ash on the Sintering Temperature

Experimental study on extraction alumina from calcium aluminate slag

Recovery of Alumina from Coal Fly Ash by CaCl2 Calcination Followed byH2SO4 Leaching

Thermal Decomposition Mechanism of Desilication Coal Fly Ash by Low-Lime Sinter Method for Alumina Extraction

Alumina Extraction from Alumina Rich Fly Ash Generated from Inner-Mongolia Chinese Coal

Effect of Five Different Additives on the Sintering Behavior of Coal Ash Rich in Sodium under an Oxy-Fuel Combustion Atmosphere