Abstract:Abstract Copper chemical mechanical polishing (CMP) in barrier layer slurries with periodate as oxidant has not been intensively studied. This work presents an investigation into copper tribocorrosion in potassium periodate-based slurries during CMP. The research focused on copper tribocorrosion behavior, the surface chemical and electrochemical reaction products, and the electrochemical mechanism during CMP. The copper surface film was characterized by Raman spectra experiments. Tribocorrosion tests combined with CMP chemical experiments were conducted to study the tribochemical behavior and wear-accelerated corrosion effect. The results show that copper corrosion is more severe in acid solutions than in alkaline conditions. The copper surface is mainly passivated with copper oxides, copper hydroxide, and copper iodide. Small amounts of copper iodate, copper periodate, and iodine could be detected under specific pH conditions. Abrasion could help to get a uniform passivation film on copper surface consisting of copper oxides, copper hydroxide, and copper iodide only. The material loss due to wear-accelerated corrosion during CMP was also investigated. The results show that under weakly alkaline conditions (pH 9 and pH 10), the wear-corrosion effect plays an important role in the total material loss due to corrosion. The wear-accelerated corrosion is mainly caused by the exposure of more cathodic reaction sites to the slurry for participation in the redox reaction and the local galvanic corrosion during the CMP process. The high wear corrosion proportion of the total corrosion (ΔIc/Icc) could help to obtain a better surface quality and desirable material removal rate during CMP.

A Study about the Different Corrosion Behavior Between Cu/Mo Bilayer and Mo/Cu/Mo Three-layer Metal Electrode

Study of Direct Cu Electrodeposition on Ultra-Thin Mo for Copper Interconnect

The Effect of Molybdenum on the Corrosion Behaviour of the High-Entropy Alloys Co1.5crfeni1.5ti0.5mox in Aqueous Environments

Effect of Mo Addition on Corrosion Behavior of High-Entropy Alloys CoCrFeNiMox in Aqueous Environments

Electrochemical Corrosion Behavior and the Related Mechanism of Ti3SiC2/Cu Composites in a Strong Acid Environment

Electrochemical Impedance Spectra for the Corrosion of Porous Cu-35mass%Ni-(5,10)mass%Cr Alloys in Molten (0.62li,0.38k)2co3 at 650 °C in Air

Electrochemical and Quantum Chemical Studies of Azoles As Corrosion Inhibitors for Mild Steel in Hydrochloric Acid

INVESTIGATION OF ELECTROCHEMICAL CORROSION BEHAVIOR OF A NEW TYPE OF Fe－Mn－Al－Cr STAINLESS STEELS

The Corrosion Behavior of C-steel, Al-alloy and Pure-Cu in Red Oak Wood Extract: A Comparative Study

An Asymmetric Metal Electrode for TFT-LCDs

Corrosion-resistant behavior and structural optimization of Ti/Cr, Ti/Cu, Cr/Cu , Ti/Cr/Cu multimetallic layer coatings in simulated seawater

A STUDY OF HOT CORROSION BEHMIOR OF Cu IN MOLTEN (Li,k)_2co_3

Correlation between the microstructure and corrosion behaviour of copper/316 L stainless-steel dissimilar-metal welded joints

The Quantitative Effect of Mo and Cu on the Stress Corrosion Cracking and Pitting Corrosion Behavior of Ultra-Pure Ferritic Stainless Steels

Tribocorrosion Study of Copper During Chemical Mechanical Polishing in Potassium Periodate-Based Slurry

Electrochemical Study Of The Corrosion Behavior Of Bronze Under Acetic Acid-Containing Thin Electrolyte Layers

Clarifying the effect of Cu element on the corrosion properties of Ni-Mo low alloy steel in marine environment

Corrosion Behaviours of the Epsilon Phase/Complex Oxide Double-Layer on Mild Steel

Corrosion Behaviors of Bulk Amorphous Fe41Co7Cr15Mo14C15B6Y2 Alloy in HCl Solution

Corrosion behaviors of bulk amorphous Fe41Co7Cr15 Mo14C15B6Y2 alloy in HCl solution

Corrosion Electrochemical Characteristics of Red Iron Oxide Pigmented Epoxy Coatings on Aluminum Alloys