Abstract:The aim of this paper is to clarify how and to what extent varied welding residual stresses (WRSes) affect the plane stress plasticity induced crack closure (PICC) simulation. A well-characterized, representative WRS field with tensile and compressive reversals was imported and the predicted PICC results were evaluated against the relevant WRS-free ones. It turned out that instead of WRS typically reported in the literature, there is actually a Kres (stress intensity factor resulting from residual stresses) controlled crack closure mechanism when investigating the PICC behavior in the presence of a WRS field, i.e., WRS influences PICC in the form of Kres. Four major categories where the crack tip was located in different Kres zones were defined using MT (middle tension) and SENT (single edge notch tension) specimens to investigate the mechanism in detail. In summary, the Kres value determined the general steady-state PICC level in the WRS field, i.e., a diminished steady-state opening stress level was predicted in the WRS field with a positive Kres regardless of whether the crack is located in a tensile or a compressive WRS zone, and an elevated value was estimated when the Kres was negative. Besides, the initial transient period was scrutinized that occurred in some WRS scenarios and the concept of primary and secondary plastic wake evolution was proposed to explain its formation. It was found that the transient behavior could be eradicated by tailoring the secondary plastic wake employing appropriate constitutive models and mesh refinement levels. The results attained in the present work provide some guidelines for the WRS-PICC modeling and simulation in the fracture mechanics community.

Plastic Mismatch Effect on Plasticity Induced Crack Closure: Fatigue Crack Propagation Perpendicularly Across a Plastically Mismatched Interface

ANALYSIS OF INTERFACE CRACKS AT A FIBER END

An elastic-plastic cohesive zone model for metal-ceramic interfaces at finite deformations

Mixed mode crack growth behaviour considering plasticity-induced and roughness-induced closure

Plasticity-induced crack closure identification during fatigue crack growth in AA2024-T3 by using high-resolution digital image correlation

On the analysis of plasticity induced crack closure in welded specimens: A mechanism controlled by the stress intensity factor resulting from residual stresses

Effect of Inhomogeneous Mechanical Properties on the Stress-Strain Field at the Crack Tip and Crack Growth Direction in Dissimilar Metal Welded Joints

Influences of material mismatch on interface crack tip field in three layered creeping materials

A Study of Particle Size Effect and Interface Fracture in Aluminum Alloy Composite Via an Extended Conventional Theory of Mechanism-Based Strain-Gradient Plasticity

Fatigue Growth Behaviour of Two Interacting Cracks with Different Crack Offset

Research on the Fatigue Crack Growth Behavior of a Zr/Ti/Steel Composite Plate with a Crack Normal to the Interface

Simulation of crack closure effect on cracked beam vibrations

Fatigue crack propagation in explosive bonded LY12/20g double-layer metal laminate: I. Face-crack

Fatigue Crack Propagation in Heterogeneous Materials under Remote Cyclic Loading

A Literature Review of Incorporating Crack Tip Plasticity into Fatigue Crack Growth Models

Study on the crack nucleation mechanism of Ti-2Al-2.5Zr alloy in low cycle fatigue: Quasi in-situ experiments and crystal plasticity simulation

Interfacial crack-tip field in anisotropic elastic solids

Elastic–plastic finite element analysis and experimental study of short and long fatigue crack growth

Experimental study of crack tip deformation under fatigue load

Investigation on the Effect of Material Mismatch Between Two Dissimilar Materials Using an Adaptive Phase-field Method

Fatigue Crack Propagation in LY12/Cu Double-Layer Metal Laminate(ⅰ)——face-Crack