Abstract:Rolling element bearings are one of the key components of many rotating machines. Through condition monitoring and vibration analysis of bearings, valuable information about the health status of the machine can be obtained, such as detection of a local fault, unbalance, and misalignment. For more than three decades, various bearing dynamic models have been developed by researchers to simulate the acceleration signal of the bearing and enhance the understanding of bearing vibration response in case of having local defects. Nevertheless, recent studies have shown that measurement of local strain in the bearing can be more effective in fault diagnosis of bearings since local strain signal is less subjected to surrounding noise and non-fault interferences. However, previously developed dynamic models lack a deep study on simulating strain signals at different locations in a bearing. Therefore, this paper presents the result of a combined lumped parameter and finite element models (FEMs) for simulating strain signals of a cylindrical roller bearing in healthy and defective conditions. Contrary to previous combined dynamic models, more realistic modeling assumptions are adopted, such as applying contact pressure to the raceway rather than concentrated nodal forces. The contact pressures are obtained from the lumped parameter model and exported to the FEM for transient analysis. The accuracy of the model in generating stress distribution is validated by a static 2D finite element contact model and theoretical formulas. Dynamic responses of the bearing, such as strain changes at different locations, are investigated in the time and frequency domains to investigate the fault symptoms such as sharp impulses and amplitude modulation. Lastly, the effect of a transmission path on strain measurement and using residual strain signal for fault diagnosis are discussed. Overall, the proposed model is an effective method for strain simulation of healthy and defective roller bearings.

Dynamic Modeling Of Machine Tool Spindle Bearing System And Model Based Diagnosis Of Bearing Fault Caused By Collision

Dynamic modeling and vibration response analysis of high speed motorized spindle

Dynamic Behavior Analysis of a Rotor-Bearing-Squeeze Film Damper Coupling System with Bearing Outer Race Localized Defect

Model for dynamic characteristics produced by inner race local defect in ball bearing system and its simulation

Dynamic Analysis of Double-Row Self-Aligning Ball Bearings Due to Applied Loads, Internal Clearance, Surface Waviness and Number of Balls

A Physics-based Model-data-driven Method for Spindle Health Diagnosis, Part II: Dynamic Simulation and Validation

Dynamic modeling considering time-varying contact pairs and parameterized defects of deep groove ball bearings for its vibration characteristic analysis

Dynamic Modeling and Simulation of Inter-Shaft Bearings with Localized Defects Excited by Time-Varying Displacement

A Physics-based Model-data-driven Method for Spindle Health Diagnosis, Part I: Modeling of Geometric Faults

Thermo-mechanical coupling model and dynamical characteristics of machining spindle-bearing system

Dynamic analysis and modeling of ball screw feed system with a localized defect on the support bearing

A fully analytical nonlinear dynamic model of spindle-holder-tool system considering contact characteristics of joint interfaces

Dynamics Prediction of Spindle System Using Joint Models of Spindle Tool Holder and Bearings

Dynamic simulation of a cylindrical roller bearing with a local defect by combining finite element and lumped parameter models

Bearing Dynamics Modeling Based on the Virtual State-Space and Hammerstein–Wiener Model

A comprehensive misalignment-rub-impact nonlinear dynamic spindle model considering contact angle and fit clearance under EHL

Multiple-degree-of-freedom dynamic model of rolling bearing with a localized surface defect

Dynamic modeling and force-vibration mapping mechanism construction of rolling bearings considering cage flexibility and local faults

Coupling modeling of thermal–dynamics–milling process for spindle system considering nonlinear characteristics

Dynamic analysis of the column-spindle system considering the nonlinear characteristics of kinematic joints

Behaviour of an Angular Contact Ball Bearing with Three-Dimensional Cubic-Like Defect: A Comprehensive Non-Linear Dynamic Model for Predicting Vibration Response