Abstract:High-resolution and multichannel time-to-digital converters (TDCs) are needed in many electrical application systems. A new multistep fine time measurement method is proposed in this work, which is based on the delay-adjustable looped carry chains to obtain both high resolution and measurement precision. Each sub-step of the fine time measurement is assigned with a different measurement resolution in the descending order by dynamically configuring the delay line length. The time residue to be measured in the following sub-step becomes smaller, so that a finer resolution can be chosen. The overall oscillation number is the summation of the oscillation number of each sub-steps. The resolution of the TDC is determined by the last sub-step. So both high-resolution and small oscillation number (corresponding to high measurement precision) can be obtained. The TDC circuit was implemented on Stratix III field programmable gate array (FPGA) chip. Test results showed that the obtained resolution was less than 10 ps, and the measurement precision root mean square (rms) was about 13 ps. The differential nonlinearity (DNL) error and the integral nonlinearity (INL) error were in the range of −1 least significant bit (LSB) to 1 LSB without any bin calibration. The resource cost per TDC channel includes the lookup table (LUT) cost of 1064 and register cost of 318. The obtained TDC is comprehensively good considering its low resource cost and high linearity, and it is promising for multichannel TDC design.

High-precision Differential Time Integrator Based on Time Adder

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

A 336fs<sub>rms</sub> 0.89mW 200MS/s 5MHz Bandwidth 2-2 MASH Time-to-Digital Converter with Differential Time-Mode Arithmetic Units

A 108fsrms 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A high precision TDC based on a multi-phase clock

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

Design of a High Speed Low Power Time-to-Digital Converter Based on Multi-stage Amplification Structure

A reconfigurable calibration-free digital-to-time converter based on a high-speed transceiver

A Current-to-voltage Integrator Using Area-Efficient Correlated Double Sampling Technique

A 108fs(Rms) 0.45mw 100ms/S 1.25mhz Bandwidth Multi-Bit Delta Sigma Time-To-Digital Converter With Dynamic Element Matching

A 1.3mW 8-bit Two-step Time-to-Digital Converter

A 6.0-Gs/s Time-Interleaved DAC Using an Asymmetric Current-Tree Summation Network and Differential Clock Timing Calibration.

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A 19 ps Precision and 170 M Samples/s Time-to-Digital Converter Implemented in FPGA with Online Calibration

A Novel Time-Multiplexed Fully Differential Interface ASIC With Strong Nonlinear Suppression for MEMS Accelerometers

A High Resolution Time-to-Digital Converter (TDC) Based on Self-Calibrated Digital-to-Time Converter (DTC).

A 12-Bit 2.5 GHz 0.37Ps-Peak-inl Digital-to-Time Converter with Parasitic-Insensitive Charge-Based Phase Interpolator