Abstract:This paper introduces a dual main clock generator (DMCG) and a digital serializer (DS) to improve the power efficiency of the time-interleaving (TI) analog-to-digital converters (ADCs). The proposed DMCG combines a dual-path front end and an improved selecting signal generator that addresses the potential phase error and reduces the peak current of the clock-driving circuits by 60%. The DS is proposed to serialize the digital outputs without employing power-hungry inverter-based buffer chains thus reducing the power consumption by 39.2%. The reference-free time skew extraction algorithm (RFA) is presented to mitigate the accuracy deterioration due to selecting the fixed middle channel. These techniques are validated by a prototype 12-bit 10-GS/s TI pipelined successive approximation register (TI-Pi-SAR) ADC. Fabricated in a 28-nm CMOS process, the prototype chip occupies an area of 4.4 mm2. The measurement results show that the ADC achieves a 49.8 dB SNDR and 60.0 dB SFDR after calibration at Nyquist frequency, while the total power consumption is 270 mW, leading to the figure of merits of Schreier (FoM ) and Walden (FoM ) of 152.5 dB and 106.9 fJ/conv.-step, respectively.

A 12-Bit 2.5 GHz 0.37Ps-Peak-inl Digital-to-Time Converter with Parasitic-Insensitive Charge-Based Phase Interpolator

A 12-Bit 0.5–2.4-GHz 0.65°-Peak-INL Parasitic-Insensitive Digital-to-Phase Converter

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A 10-Bit 563-Fs Step Constant-Slope Digital-to-Time Converter in 40-Nm CMOS with Nonlinearity Cancellation and Range Extension Techniques

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

A 5-Bit, 87-Fs Step, Constant-Slope, Charge-Sharing-Based Encoding Digital-to-Time Converter in 130nm CMOS

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A 1ps Resolution Two-Step Time-to-digital Converter Using Parallel Digital-to-time Converters

A 108fsrms 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A 1.3mW 8-bit Two-step Time-to-Digital Converter

A high precision TDC based on a multi-phase clock

A Phase Lookahead DTC for Fast Settling Switched Loop DPLL

Design of a High Speed Low Power Time-to-Digital Converter Based on Multi-stage Amplification Structure

A High Resolution Time-to-Digital Converter (TDC) Based on Self-Calibrated Digital-to-Time Converter (DTC).

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A 10b, 0.7ps resolution coarse-fine time-to-digital converter in 65nm CMOS using a time residue amplifier

A 108fs(Rms) 0.45mw 100ms/S 1.25mhz Bandwidth Multi-Bit Delta Sigma Time-To-Digital Converter With Dynamic Element Matching

Photonic-Assisted Time-Interleaved Adc Based on Optical Delay Line

A Power-Efficient Clock Circuit and Output Serializing Technique Integrated in a 12-bit 10-GS/s ADC