Abstract:Heavy metals in industrial wastewaters are typically present as stable metal–organic complexes with their cost-effective treatment remaining a significant challenge. Herein, a self-enhanced decomplexation scenario is developed using an electrochemical membrane filtration (EMF) system for efficient decomplexation and Cu recovery. Using Cu-EDTA as a model pollutant, the EMF system achieved 81.5% decomplexation of the Cu-EDTA complex and 72.4% recovery of Cu at a cell voltage of 3 V. The •OH produced at the anode first attacked Cu-EDTA to produce intermediate Cu-organic complexes that reacted catalytically with the H2O2 generated from the reduction of dissolved oxygen at the cathode to initiate chainlike self-enhanced decomplexation in the EMF system. The decomplexed Cu products were further reduced or precipitated at the cathodic membrane surface thereby achieving efficient Cu recovery. By scavenging H2O2 (excluding self-enhanced decomplexation), the rate of decomplexation decreased from 8.8 × 10–1 to 4.1 × 10–1 h–1, confirming the important role of self-enhanced decomplexation in this system. The energy efficiency of this system is 93.5 g kWh–1 for Cu-EDTA decomplexation and 15.0 g kWh–1 for Cu recovery, which is much higher than that reported in the previous literature (i.e., 7.5 g kWh–1 for decomplexation and 1.2 g kWh–1 for recovery). Our results highlight the potential of using EMF for the cost-effective treatment of industrial wastewaters containing heavy metals.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.est.0c05554?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.est.0c05554</a>.Section S1: Assembly of the membrane module; Section S2: Setup of the EMF reactor; Section S3: Setup of the H-type two-compartment electrochemical cell; Section S4: Characterizations of the titanium mesh and conductive membrane; Section S5: Membrane properties of the conductive membrane; Section S6: Filtration test of the conductive membrane using real wastewater; Section S7: Evolution of H2O2 concentration during each experiment; Section S8: TMP evolution during the experiment; Section S9: Rate constants obtained in the two-compartment cell experiment; Section S10: Desorption results of each experiment; Section S11: Intermediates formed at different voltages; Section S12: Decomplexation experiments of each Cu-organic complex; Section S13: Evolution of the Cu(I) species concentration during each experiment; Section S14: Probability of decomplexation or reduction/precipitation of certain intermediates; Section S15: Cyclic voltammograms under an anodic scan; Section S16: Decomplexation and Cu recovery performance in the treatment of real wastewater; Section S17: mass transfer rate constant calculation; and Section S18: Energy efficiency and EE/O calculation (<a class="ext-link" href="/doi/suppl/10.1021/acs.est.0c05554/suppl_file/es0c05554_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

High-efficient Synergistic Extraction of Co(II) and Mn(II) from Wastewater Via Novel Microemulsion and Annular Centrifugal Extractor

The Efficient Removal of Low Concentration Hexavalent Chromium Via Combining Charged Microporous Membrane and Micellar Adsorption Filtration

A Microextraction Approach for Rapid Extraction and Separation of Mn(II) and Co(II) Using Saponified D2EHPA System

Coextraction of vanadium and manganese from high-manganese containing vanadium wastewater by a solvent extraction-precipitation process

Microbial Electrolysis Cells with Biocathodes and Driven by Microbial Fuel Cells for Simultaneous Enhanced Co(II) and Cu(II) Removal

Selective Co-Extraction of Critical Metals from Deep Ocean Polymetallic Nodule Leachate and Preparation of Battery-Grade Ni-Co-Mn Solution

Extraction of Co~(2+) and Cd~(2+) from Wastewater Using Hydrophobic Ionic Liquids as Solvents

An Effective Strategy to Construct Ph-Responsive Microemulsion for Cobalt Recovery and Its Responsive Mechanisms

A Green and Efficient Process for the Stepwise Extraction of Cu, Ni, Co, Mn, and Li from Hazardous Waste with a Novel Solvent Extraction System of D2EHPA-NNPA

Recovery of Manganese Ions from Aqueous Solutions with Cyanex 272 Using Emulsion Liquid Membrane Technique: A Design of Experiment Study

Self-Enhanced Decomplexation of Cu-Organic Complexes and Cu Recovery from Wastewaters Using an Electrochemical Membrane Filtration System

A Novel Approach for Recovery of Manganese from On-Site Manganese-Bearing Wastewater

Synergistic Extraction and Selective Removal of Cu2+ from Aqueous Solution Using Magnetic Nanoparticles Coated with Mixtures of Sodium Oleate and Saponified 2-Ethylhexyl Phosphonic Acid Mono-2-Ethylhexyl Ester

Highly efficient Mn2+, Mg2+, and NH4+ recovery from electrolytic manganese residue via leaching, solvent extraction, coprecipitation, and atmospheric oxidation

Removal of Co(II) and various metal ions from the residue of the zinc plant through solvent extraction using both acid and neutral extractants

A Novel Process on Separation of Manganese from Calcium and Magnesium Using Synergistic Solvent Extraction System

Cobalt Ion Extraction from Wastewater by P<sub>204 </sub>Microemulsion Saponified

Synthesis of MnFe2O4@Mn-Co oxide core-shell nanoparticles and their excellent performance for heavy metal removal.

Cobalt Ion Extraction from Wastewater by P204 Microemulsion Saponified

Enhanced synergistic removal of Cu(II) and Cr(VI) with multifunctional biomass hydrogel from strong-acid media

An Electrochemical Strategy for Simultaneous Heavy Metal Complexes Wastewater Treatment and Resource Recovery.