Abstract:We report on the results of a comparative study of the structural and physicochemical characteristics of cotton fiber samples carbonized by the microwave and conventional thermal methods. The temperature evolution of the samples during the microwave carbonization process has been established. The morphological heterogeneity of the fiber surface over the microwave-carbonized sample cross section has been found. It is shown that fibers of the surface layers are subjected to the destruction of two kinds: (i) numerous transverse brittle fractures and fiber coloring at the places of swelling (a sharp increase in the fiber diameter) and (ii) fluffing of the surface into twisted fibrils with a transverse size of 50–300 nm due to destruction of the outer layers of a fiber secondary wall. In the central part of a sample, fibers are destructed via the formation of longitudinal interfibrillary slits and stratification of the fiber secondary wall, which leads to the formation of pores 50–200 nm in size. It has established that, during the microwave carbonization process, the central part of a sample is almost completely freed up of impurities, which are deposited onto fibers of the surface layers. It is demonstrated that the integral adsorption capacity of the microwave-carbonized sample is higher than the adsorption capacity of the sample carbonized by the thermal method (126 and 47 mg/g, respectively). It has been found that, under microwave exposure for more than 10 min, areas with an adsorption capacity of about 350–450 mg/g arise in the carbonized material, which is comparable with the value for the samples activated by the conventional method.

Microwave Treatment of Pre-Oxidized Fibers for Improving Their Structure and Mechanical Properties

Comparative Study of Conventional and Microwave Heating of Polyacrylonitrile-Based Fibres

Study on Structure Evolution and Reaction Mechanism in Microwave Pre-oxidation

Microwave Radiation Effects on Carbon Fibres Interfacial Performance

Study on the Oxidative Stabilization of Polyacrylonitrile Fibers by Microwave Heating

A Two-Step Microwave Annealing Process for PAN Pre-Oxidation through a TM-Mode Cavity

Research on dynamic microwave low-temperature carbonization of high performance carbon fiber

EFFECT OF MICROWAVE IRRADIATION ON GRAPHITIZATION OF CARBON MATRIX IN PULVERIZED COAL

Microwave heating oxidative stabilization of KMnO4 modified polyacrylonitrile-based carbon fiber precursor

The Effect of Microwave Treatment on the Hydrogen Peroxide Bleaching of Soda-AQ Wheat Straw Pulp

Effects of microwave on the structural and emulsifying properties and interfacial properties of oxidized soybean protein aggregates

Effect of Carbonization Temperature on Microwave Absorbing Properties of Polyacrylonitrile-Based Carbon Fibers

Microwave pretreatment of logs for saving energy and improving paper properties during mechanical pulping

Study on preparation of high cyclization degree and high strength pre-oxidized fiber by nitration

Microwave Carbonization of Cotton Fiber for Production of Carbon Materials

Influence of Heat Treatment Temperature on the Properties of PBO Fibers

Study on the structural evolution of polyacrylonitrile fibers in stepwise heat treatment process and its relationship with properties

The oxidation of carbon fiber on the interlaminar shear strength and tribological properties of high-density polyethylene composites

Effect of oxygen content on the preoxidation structure of polyacrylonitrile fibers

Degradation of lignin induced by microwave treatment of straw pulp

Effect of pre-oxidation temperature and heating rate on the microstructure of lignin carbon fibers