Abstract:The beneficial effect of the alkali metals such as Na and K on the Cu(In,Ga)Se-2 (CIGS) and Cu2ZnSn(S,Se)(4) (CZTSSe) solar cells has been extensively investigated in the past two decades, however, in most of the studies the alkali metals were treated as dopants. Several recent studies have showed that the alkali metals may not only act as dopants but also form secondary phases in the absorber layer or on the surfaces of the films. Using the first-principles calculations, we screened out the most probable secondary phases of Na and K in CIGS and CZTSSe, and studied their electronic structures and optical properties. We found that all these alkali chalcogenide compounds have larger band gaps and lower VBM levels than CIGS and CZTSSe, because the existence of strong p-d coupling in CIS and CZTS pushes the valence band maximum (VBM) level up and reduces the band-gaps, while there is no such p-d coupling in these alkali chalcogenides. This band alignment repels the photo-generated holes from the secondary phases and prevents the electron-hole recombination. Moreover, the study on the optical properties of the secondary phases showed that the absorption coefficients of these alkali chalcogenides are much lower than those of CIGS and CZTSSe in the energy range of 0-3.4eV, which means that the alkali chalcogenides may not influence the absorption of solar light. Since the alkali metal dopants can passivate the grain boundaries and increase the hole carrier concentration, and meanwhile their related secondary phases have innocuous effect on the optical absorption and band alignment, we can understand why the alkali metal dopants can improve the CIGS and CZTSSe solar cell performance. (C) 2017 Science Pressand Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. and Science Press. All rights reserved.

Lithium/Silver-Doped Cu$_{2}$ZnSnS$_{4}$ with Tunable Band Gaps and Phase Structures: a First-Principles Study

Determining and Controlling the Stoichiometry of Cu2ZnSnS4 Photovoltaics: the Physics and Its Implications

A Strategy to Stabilize Kesterite Czts for High-Performance Solar Cells

Stability and Electronic Structure of Cu2znsns4 Surfaces: First-Principles Study

Strategy for Performance Enhancement of Cd1-XZnXTe/CdS Core/shell Quantum Dot Sensitized Solar Cells Through Band Adjustment

First Principles Calculation Study of Zn1-xMgxO/Cu2ZnSnS4 Heterointerface

Structural, Electronic and Optical Properties of Bandgap-Tunable Cu 2 ZnSi X Sn 1− X Se 4 Alloys

Tunable band structure and effective mass of disordered chalcopyrite

Defect Engineering in Earth‐Abundant Cu2ZnSn(S,Se)4 Photovoltaic Materials Via Ga3+‐Doping for over 12% Efficient Solar Cells

Disorder induced band gap lowering in kesterite type Cu 2 ZnSnSe 4 and Ag 2 ZnSnSe 4 : A first-principles and special quasirandom structures investigation

Li-based Selenized Cu2ZnSnS4 Surface: Possible Route to Overcoming Voc-Deficit of Kesterite Solar Cells

First-principles Study on the Alkali Chalcogenide Secondary Compounds in Cu(In,Ga)Se-2 and Cu2ZnSn(S,Se)(4) Thin Film Solar Cells

Synergetic Effects of Zn Alloying and Defect Engineering on Improving the CdS Buffer Layer of Cu2ZnSnS4 Solar Cells

Crystal And Electronic Band Structure Of Cu2znsnx4 (X=S And Se) Photovoltaic Absorbers: First-Principles Insights

Improving the Optical and Thermoelectric Properties of Cs2InAgCl6 with Substitutional Doping: A DFT Insight

Substitution of Ag for Cu in Cu2ZnSn(S,Se)4: Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

High Efficiency Cu2ZnSn(S,Se)4 Solar Cells with Shallow LiZn Acceptor Defects Enabled by Solution‐Based Li Post‐Deposition Treatment

High Efficiency Cu 2 ZnSn(S,Se) 4 Solar Cells with Shallow Li Zn Acceptor Defects Enabled by Solution‐Based Li Post‐Deposition Treatment

Intrinsic Point Defects and Complexes in the Quaternary Kesterite Semiconductorcu2znsns4

CdS(In)/CZTSSe bandgap alignment engineering for performance enhancement of solar cells without ZnO layer

Synthesis and characterization of lithium-doped copper zinc tin sulfide (CZTS) thin films