Abstract:Introduction Prevention of accidental dust explosions is an important subject for safety management in industrial processes, in which combustible powders are handled. Once a dust explosion happens in the processes, it will cause serious harms. To appropriately prevent accidental dust explosions and suppress the damages, it is important to properly understand dust explosion phenomena. That is, it is essential to understand how a flame is formed and propagates in a combustible dust cloud. However, such basic aspects have not been clear yet, because combustion in a dust cloud is a complex phenomenon taking place in heterogeneous system. Most of previous studies about dust explosions have been focused on only practical subjects, such as the minimum ignition energy, explosion concentration limits, rate of pressure rise, and explosion pressure [1, 2]. Flammability lean limits are of practical importance for prevention of dust and gas explosions. Some of the measured results of flammability lean limits are shown in Table 1 [1-3]. In this table, concentration is indicated in equivalence ratio (calculated on the assumption that all combustible solid vaporizes), it is found that the lean limits of combustible dusts are one-second or one-third smaller than that of combustible gases. It expresses the dangerousness of combustible dust clouds, however, the reason of this feature has not been clarified yet. In our recent study [4], behavior and structure of an iron dust flame have been examined in detail, and the structure of the combustion region and particle behavior near the flame have been clarified. It was found that particle velocity differs from gas flow velocity. In this kind of flame propagation (velocity is less than a few ten cm/s), the density of gas ahead of combustion region (preheat zone) is almost constant. If particles exactly follow the gas flow movement, number density of particles becomes constant in the region ahead of the combustion zone. However, as mentioned above, the particle velocity differs from the gas flow velocity, therefore, particle number density varies as the particle approaches to the combustion zone. This phenomenon must influence the flammability lean limits. In this study, distributions of particle number density and particle velocity were measured near a flame propagating through an iron particle cloud. Measured distribution of particle number density was compared with that estimated by the velocity distribution.

Flame Propagation Behaviors and Influential Factors of TiH2 Dust Explosions at a Constant Pressure

Experimental Study of Flame Propagating Behaviors Through Titanium Particle Clouds

Inhibitory Effects of Typical Inert Gases on the Flame Propagation and Structures in TiH2 Dust Clouds

Secondary Explosion Characteristics of TiH2 Dust Induced by Hydrogen-Oxygen Detonations

Hybrid H2/Ti dust explosion hazards during the production of metal hydride TiH2 in a closed vessel

Inhibitory effects of typical inert gases on the flame propagation and structures in TiH 2 dust clouds

Dynamics of Premixed Hydrogen-Air Flame Propagation in the Duct with Pellets Bed

Flame propagation mechanisms in dust explosions

Turbulent Burning Velocity of Hydrogen/n-Heptane/air Propagating Spherical Flames: Effects of Hydrogen Content

Ignition Sensitivity and Flame Propagation of Titanium Powder Cloud

Flame structures and particle-combustion mechanisms in nano and micron titanium dust explosions

Deflagration Characteristics of Freely Propagating Flames in Magnesium Hydride Dust Clouds

Effects Investigation of Particle Size and Concentration on the Ignition, Explosion Characteristics, and Behavior of Flame Propagation in TC4 Titanium Alloys

Investigation on the Flame and Pressure Behaviors of Vented Hydrogen-Air Deflagration from a Duct-Connected Vessel: Effects of Venting Diameter and Static Activation Pressure

Effect of hydrogen addition on explosion characteristics of premixed methane/air mixture under different equivalence ratio distributions

Flame Propagation Characteristics of Natural Gas-Hydrogen-Air Mixtures

Premixed Flame Propagation in Hydrogen Explosions

Experimental investigation of spontaneous ignition and flame propagation at pressurized hydrogen release through tubes with varying cross-section.

Effect of low volume fraction of H 2 on explosion characteristics and mechanism of AlH 3 dust via connected container

Effect of Low Volume Fraction of H2 on Explosion Characteristics and Mechanism of AlH3 Dust Via Connected Container

Distribution of Particle Number Density near an Iron Dust Flame