Distribution of Particle Number Density near an Iron Dust Flame

Jin-hua SUN,Ritsu DOBASHI

1999-01-01

Abstract:Introduction Prevention of accidental dust explosions is an important subject for safety management in industrial processes, in which combustible powders are handled. Once a dust explosion happens in the processes, it will cause serious harms. To appropriately prevent accidental dust explosions and suppress the damages, it is important to properly understand dust explosion phenomena. That is, it is essential to understand how a flame is formed and propagates in a combustible dust cloud. However, such basic aspects have not been clear yet, because combustion in a dust cloud is a complex phenomenon taking place in heterogeneous system. Most of previous studies about dust explosions have been focused on only practical subjects, such as the minimum ignition energy, explosion concentration limits, rate of pressure rise, and explosion pressure [1, 2]. Flammability lean limits are of practical importance for prevention of dust and gas explosions. Some of the measured results of flammability lean limits are shown in Table 1 [1-3]. In this table, concentration is indicated in equivalence ratio (calculated on the assumption that all combustible solid vaporizes), it is found that the lean limits of combustible dusts are one-second or one-third smaller than that of combustible gases. It expresses the dangerousness of combustible dust clouds, however, the reason of this feature has not been clarified yet. In our recent study [4], behavior and structure of an iron dust flame have been examined in detail, and the structure of the combustion region and particle behavior near the flame have been clarified. It was found that particle velocity differs from gas flow velocity. In this kind of flame propagation (velocity is less than a few ten cm/s), the density of gas ahead of combustion region (preheat zone) is almost constant. If particles exactly follow the gas flow movement, number density of particles becomes constant in the region ahead of the combustion zone. However, as mentioned above, the particle velocity differs from the gas flow velocity, therefore, particle number density varies as the particle approaches to the combustion zone. This phenomenon must influence the flammability lean limits. In this study, distributions of particle number density and particle velocity were measured near a flame propagating through an iron particle cloud. Measured distribution of particle number density was compared with that estimated by the velocity distribution.