Sulfonated Oligomer-crosslinked Fluorinated Poly(aryl ether sulfone)-based Proton Exchange Membranes for Fuel Cells

Xuan Zhang,Y. Lu,X. Yan,Zhaoxia Hu,Shouwen Chen

DOI: https://doi.org/10.1002/fuce.201700166

IF: 2.948

2018-01-01

Fuel Cells

Abstract:A series of sulfonated oligomer-crosslinked fluorinated poly(aryl ether sulfone) membranes (c-SPFAES) have been prepared in a consecutive casting and thermal treating process from fluorinated polymers and sulfonated oligomers, where the latter acted as hydrophilic grafts and crosslinkers at the same time. Membrane structure and physico-chemical properties are characterized and evaluated by 1H-nuclear magnetic resonance spectroscopy, Fourier transform infrared spectroscopy, thermogravimetric analysis and atomic force microscopy, Fenton, water-swelling and H-2/O-2 single cell tests. For the c-SPFAES membranes with ion exchange capacity of 1.04-1.78 mmol g(-1), they exhibit excellent mechanical toughness with Young's moduli above 1.3 GPa and tensile strength beyond 35.8 MPa, good dimensional and thermo-oxidative stability. They also exhibited clear hydrophilic-hydrophobic phase-separation morphology. The proton conductivity is higher than 0.1 S cm(-1) for the c-SPFAES membranes with IEC over 1.38 mmol g(-1) at 60 degrees C. In a H-2/O-2 single cell test, the maximum power density of the c-SPFAES-1.61 membrane achieves 587 mW cm(-2) at 80 degrees C under fully hydrated state. The c-SPFAES membrane show promising potentials as a polymer electrolyte membrane candidate for fuel cell applications.