Abstract:Theoretical and experimental investigations on the machining performance and mechanisms in single-point diamond turning (SPDT) of ZnSe aspheric surfaces using straight-nosed cutting tools have been carried out. Analyses of the chip formation process have shown that using straight-nosed cutting tools can significantly reduce the cut thickness by about 60 % compared with using round-nosed cutting tools for facilitating the ductile-mode material removal and reducing surface damages. The analyses have also shown that the height of residual feed marks can be reduced by using the straight-nosed cutting tools by about 80 %, which can further improve the machined surface integrity. Experiments on the machining performance of using straight-nosed and round-nosed cutting tools were conducted to verify the analytical deductions. It has been shown that nano-scale surface finish with surface roughness Ra -1.5 nm can be achieved by using straight-nosed cutting tools, which is significantly improved comparing with that by the round-nosed cutting tools (Ra -7.8 nm) and is consistent with the analytical results. Needle-like chip with periodical layered structure was collected from the SPDT processes using straight-nosed cutting tools, indicating a relatively continuous chip formation process under the ductile-mode material removal. Raman spectroscopy has shown increased metallization of ZnSe occurred during the machining with straight-nosed cutting tools, which is considered to reduce the brittle fractures along with the chip formation process. It has been further found that the straight-nosed cutting tool can reduce work adhesion and micro-edge chipping of cutting tools for extending the cutting tool life.

Research on Single Point Diamond Turning of Chalcogenide Glass Aspheric Lens

Aspheric Lens Processing of Chalcogenide Glass Via Combined PGM-SPDT Process

Experimental Study on Precision Molding of Small Dual Aspherical Chalcogenide Glass Lens

Selection of Preform in Glass Molding Press of Aspherical Chalcogenide Lens

One-Point Nano-Grinding for Micro-Aspherical Glass Lens Mould

Ultra-Precision Cutting Of Fresnel Lenses On Single Crystal Germanium And The Machining Processing Analysis

Fabrication of Microglass Lens Mould by Using Ultraprecision Microgrinding Process

Fabrication of the optical lens on single-crystal germanium surfaces using the laser-assisted diamond turning

Demonstration of High-Performance, Sub-Micron Chalcogenide Glass Photonic Devices by Thermal Nanoimprint

A Review of the Precision Glass Molding of Chalcogenide Glass (ChG) for Infrared Optics

Investigation of Surface Integrity Induced by Ultra-Precision Grinding and Scratching of Glassy Carbon

Surface and Subsurface Integrity in Diamond Grinding of Optical Glasses on Tetraform ‘C’

Ductile machining of single-crystal silicon for microlens arrays by ultraprecision diamond turning using a slow tool servo

Understanding Aging in Chalcogenide Glass Thin Films Using Precision Resonant Cavity Refractometry

Study on Ultra-Precision Grinding Machining of Optical Aspheric Surface

Surface Generation and Materials Removal Mechanism in Ultra-Precision Grinding of Biconical Optics Based on Slow Tool Servo with Diamond Grinding Wheels

Investigation on the Ultra-Precision Diamond Turning of ZnSe Aspheric Surfaces Using Straight-Nosed Cutting Tools

Fabrication of aspheric diffractive lens with high precision by precision glass molding

Single Grit Diamond Grinding of Spectrosil 2000 Glass on Tetraform 'C'

Enhancing ductile regime ultra-precision diamond turning of curved zinc selenide (ZnSe) optics by using straight-nosed diamond tools with cutting-edge-slipping

Cutting depth-oriented surface morphology control in diamond-turning brittle single-crystal germanium