Abstract:This study presents a colloidal synthesis method to produce thermoelectric Cu3SbSe4 nanocrystals with high yield. Pb doping is employed to increase carrier concentration and effective mass, confirmed by experimental studies and theoretical calculations. Additionally, lattice distortions and other intriguing nanostructures are found to significantly reduce thermal conductivity. Consequently, the thermoelectric figure of merit zT is greatly enhanced. Developing cost‐effective and high‐performance thermoelectric (TE) materials to assemble efficient TE devices presents a multitude of challenges and opportunities. Cu3SbSe4 is a promising p‐type TE material based on relatively earth abundant elements. However, the challenge lies in its poor electrical conductivity. Herein, an efficient and scalable solution‐based approach is developed to synthesize high‐quality Cu3SbSe4 nanocrystals doped with Pb at the Sb site. After ligand displacement and annealing treatments, the dried powders are consolidated into dense pellets, and their TE properties are investigated. Pb doping effectively increases the charge carrier concentration, resulting in a significant increase in electrical conductivity, while the Seebeck coefficients remain consistently high. The calculated band structure shows that Pb doping induces band convergence, thereby increasing the effective mass. Furthermore, the large ionic radius of Pb2+ results in the generation of additional point and plane defects and interphases, dramatically enhancing phonon scattering, which significantly decreases the lattice thermal conductivity at high temperatures. Overall, a maximum figure of merit (zTmax) ≈ 0.85 at 653 K is obtained in Cu3Sb0.97Pb0.03Se4. This represents a 1.6‐fold increase compared to the undoped sample and exceeds most doped Cu3SbSe4‐based materials produced by solid‐state, demonstrating advantages of versatility and cost‐effectiveness using a solution‐based technology.

Synthesis of Rock Salt Pb1-xSrxTe with Unusual Stabilized Compositions and Their Electrochemical Performance

Synthesis of nanocrystalline lead chalcogenides PbE (E = S, Se, or Te) from alkaline aqueous solutions

Nanoscale Stabilization of New Phases in the PbTe-Sb2Te3 System: Pb(m)Sb(2n)Te(m+3n) Nanocrystals.

Composition and shape control of single-crystalline Ba1-xSrxTiO3 (x=0-1) nanocrystals via a solvothermal route

Stable All-Solid-state Li-Te Battery with Li3TbBr6 Superionic Conductor

Critical Role of Tellurium Self-Compensation in Enhancing the Thermoelectric Performance of P-Type Bi0.4Sb1.6Te3 Alloy

Improved Solubility in Metavalently Bonded Solid Leads to Band Alignment, Ultralow Thermal Conductivity, and High Thermoelectric Performance in SnTe

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Alloying behavior of wide band gap alkaline-earth chalcogenides

Synthesis of PbTe thermoelectric materials by alkaline reducing chemical routes

Hydrothermal Synthesis, Characterization, and Influence Factors of PbTe Nanocrystals

Controllable Synthesis of PbTe Nanosheets Via an Alkaline Hydrothermal Method

High-throughput computational screening of Sb–Te binary alloys for phase-change storage applications

Enhancing the Thermoelectric and Mechanical Properties of p-Type PbS through Band Convergence and Microstructure Regulation

Nanostructures Boost the Thermoelectric Performance of PbS

Anionic chemistry regulation boosting the reversible redox in CoSe x Te y @C polyhedrons for sodium storage

Thermoelectric properties of Na-doped PbTe0 .8-xSe0 .2 Sx alloys

Fast Preparation and High Thermoelectric Performance of the Stable Bi 0.5 Sb 1.5 Te 3 Bulk Materials for Different Synthesis Pressures

High Thermoelectric Performance of Ge1−xPbxSe0.5Te0.5 Due to (pb, Se) Co-Doping

Manipulating Pb Vacancies Achieved Ultra‐High Thermoelectrics in Quaternary Pb0.95Na0.04Te1‐xSex via Fine‐Tuning Se Solubility

Melt-slow Cooling Synthesis and Thermoelectric Properties of Pb9.6SbmTe3Se7 Alloys