Abstract:Fiber-optic sensors have numerous existing and emerging applications spanning areas from industrial process monitoring to medical diagnosis. Two of the most common fiber sensors are based on the fabrication of Bragg gratings or Fabry-Perot etalons. While these techniques offer a large array of sensing targets, their utility can be limited by the difficulties involved in fabricating forward viewing probes (Bragg gratings) and in obtaining sufficient signal-to-noise ratios (Fabry-Perot systems). In this article we present a micro-scale fiber-optic force sensor produced using direct laser writing (DLW). The fabrication entails a single-step process that can be undertaken in a reliable and repeatable manner using a commercial DLW system. The sensor is made of a series of thin plates (i.e. Fabry-Perot etalons), which are supported by springs that compress under an applied force. At the proximal end of the fiber, the interferometric changes that are induced as the sensor is compressed are read out using reflectance spectroscopy, and the resulting spectral changes are calibrated with respect to applied force. This calibration is performed using either singular value decomposition (SVD) followed by linear regression or artificial neural networks. We describe the design and optimization of this device, with a particular focus on the data analysis required for calibration. Finally, we demonstrate proof-of-concept force sensing over the range 0-50 mu N, with a measurement error of approximately 1.5 mu N. Published by The Optical Society under the terms of the Creative Commons Attribution 4.0 License.

High-sensitive Optical Force Sensor Based on Enhanced Effective Index Modulation

High-sensitivity Temperature-Independent Force Sensor Based on PS-LPFG Formed by Inserting a Microbend

High-Sensitivity Microfiber Strain and Force Sensors

Highly sensitive force sensor based on optical microfiber asymmetrical Fabry-Perot interferometer.

Highly Sensitive Bending Sensor Based on C-Shaped-Core Long-Period Fiber Gratings

Optical Nanofiber-Enabled Self-Detection Picobalance

Strain Force Sensor with Ultra-High Sensitivity Based on Fiber Inline Fabry-Perot Micro-Cavity Plugged by Cantilever Taper

An Optical Contact Force Sensor for Tactile Sensing Based on Specklegram Detection from Concatenated Multimode Fibers

Ultra-highly Sensitive Surface-Corrugated Microfiber Bragg Grating Force Sensor

High-sensitivity Strain Sensor Based on a Helical-Core Long-Period Fiber Grating.

Highly Sensitive Two-Axis Bending Sensor Based on Arc-Induced Long Period Fiber Grating in Dual Side-Hole Fiber

Highly Sensitive Force Sensor Based on Balloon-Like Interferometer

Sensitivity-Enhanced Strain Sensor With a Wide Dynamic Range Based on a Novel Long-Period Fiber Grating

High-sensitivity Photonic Crystal Fiber Force Sensor Based on Sagnac Interferometer for Weighing

High-sensitivity Bending Vector Sensor Based on Γ-Shaped Long-Period Fiber Grating

Micro-scale fiber-optic force sensor fabricated using direct laser writing and calibrated using machine learning.

All fiber compact bending sensor with high sensitivity based on a multimode fiber embedded chirped long-period grating.

Ultrasensitive Strain Sensor Based on Core-Bending Long Period Fiber Grating

Highly Sensitive Vector Bending Sensor Based on an Embedded Multimode D-shaped LPFG.

A High Sensitivity Pressure Sensor Based on Twisted Long-Period Fiber Grating

Development of a Microforce Sensor Based on a Fiber Bragg Grating Used for Micro-/Nanomanipulation.