Abstract:ORCs (Organic Rankine Cycles) are of great significance for energy conservation and CO2 emission reductions owing to their usage in converting low grade waste heat to electrical power. The working fluid properties are the key to getting good cycle performance. The advantages of CO2 and hydrocarbon working fluids for use in ORCs are investigated here for six binary mixtures: CO2+propane/n-butane/iso-butane/n-pentane/iso-pentane/neo-pentane. A transcritical ORC simulation program was used to predict the cycle performance for various hydrocarbon mass fraction working fluids for a turbine inlet temperature of 453.15 K and inlet pressure of 1.3pc. The predicted cycle performance is used to divide the six working fluids into three categories relative to the thermal efficiency of an ORC using pure CO2. The first working fluid type (CO2+propane) has increasing efficiencies with increasing hydrocarbon mass fraction while the second type have maximum thermal efficiencies at hydrocarbon mass fractions of 0.3, and the third type has maximums at a mass fraction of 0.2. In addition, the thermodynamics relative efficiency, ξ, is highest for CO2+propane and then decreases for CO2+iso-butane, CO2+ n-butane, CO2+neo-pentane, CO2+iso-pentane, and CO2+n-pentane with the lowest. Then, the cycle efficiencies of the three working fluid types were analyzed from the perspective of the hydrocarbon molecular structure. The results show that longer main carbon chains and branched carbon chains have larger pc and Tc, with this critical property leading to higher efficiencies at low hydrocarbon mass fractions. Lower p′c and T′c lead to higher efficiencies at high hydrocarbon concentrations. Thus, there is a trade-off between the cycle efficiency and the hydrocarbon mass fraction. Finally, the three best working fluid mixtures, 0.3CO2/0.7propane, 0.7CO2/0.3neo-pentane and 0.8CO2/0.2pentane, were further analyzed according to their cycle characteristics. The 0.3CO2/0.7propane mixture working fluid had the best cycle efficiency for these conditions.

Influence of Alkane Working Fluid Decomposition on Supercritical Organic Rankine Cycle Systems

Advances in Working Fluids for Organic Rankine Cycle

Optimization of Organic Rankine Cycle Involving Operating Conditions and Work Fluids and Heat Integration

Simultaneous Optimization for Organic Rankine Cycle Design and Heat Integration

Review of the Working Fluid Thermal Stability for Organic Rankine Cycles

Working Fluid Selection for a Small-Scale Organic Rankine Cycle Recovering Engine Waste Heat

Cooperative Optimization of System Parameters and Heat Exchanger Structure for Geothermal Organic Rankine Cycle

Comparison study of Trilateral Rankine Cycle, Organic Flash Cycle and basic Organic Rankine Cycle for low grade heat recovery

Chemical Thermodynamics Prediction Method for the Working Fluid Thermal Stability

A novel method for predicting the thermal stabilization temperature of organic Rankine cycle system working fluids based on transition state theory

Exploration and Analysis of CO2 + Hydrocarbons Mixtures As Working Fluids for Trans-critical ORC

Thermal Stability of Some Hydrofluorocarbons As Supercritical ORCs Working Fluids

Thermal Stability and Material Compatibility for Hexamethyldisiloxane As the Working Fluids of Organic Rankine Cycle

An examination of super dry working fluids used in regenerative organic Rankine cycles

Thermodynamic analysis of working fluids: What is the highest performance of the sub- and trans-critical organic Rankine cycles?

Research progress of the Organic Rankine Cycle working fluids thermal stability

Thermal stability of a mixed working fluid (R513A) for organic Rankine cycle

Experimental Investigations on Dynamic Performance of Organic Rankine Cycle Integrated with Latent Thermal Energy Storage under Transient Engine Conditions

Analysis of the Thermodynamic Performance Limits of the Organic Rankine Cycle in Low and Medium Temperature Heat Source Applications

Organic Rankine cycle performance evaluation and thermoeconomic assessment with various applications part I: Energy and exergy performance evaluation

A Working Fluid Assessment for a Biomass Organic Rankine Cycle under Different Conditions