Abstract:In this paper, an exploration of the practical thermodynamic performance limits of the organic Rankine cycle (ORC) under working fluid and cycle parameter restrictions is presented. These performance limits are more realistic benchmarks for the thermodynamic cycle than the efficiency of the Carnot cycle. Subcritical ORC configuration with four typical case studies that are related to temperature ranging from 373.15 to 673.15 K is taken into account. The ORC is defined by its cycle parameters and working fluid characteristic properties. The cycle parameters involve evaporation temperature ( T eva ), condensation temperature ( T con ) and superheat degree (Δ T sup ), while the working fluids are represented by the characteristic properties including critical temperature ( T c ), critical pressure ( p c ), acentric factor ( ω ), and molar ideal gas isobaric heat capacity based on the principle of corresponding states. Subsequently, Pareto optimum solutions for obtained hypothetical working fluids and cycle parameters are achieved using multi-objective optimization method with the consideration of both thermal efficiency ( η th ) and volumetric power output (VPO). Finally, sensitivity analysis of the working fluid characteristic properties is conducted, and the second law of thermodynamics analysis, especially the applicability of entropy generation minimization, is performed. The results show that the current commonly used working fluids are widely scattered below the Pareto front that represents the tradeoff between η th and VPO for obtained hypothetical fluids. T eva and T con are the most dominant cycle parameters, while T c and ω tend to be the most dominant characteristic property parameters. The entropy generation minimization does not give the same optimal results.

Review of the Working Fluid Thermal Stability for Organic Rankine Cycles

Advances in Working Fluids for Organic Rankine Cycle

Thermal stability and pyrolysis mechanism of working fluids for organic Rankine cycle: A review

Working Fluid Selection for a Small-Scale Organic Rankine Cycle Recovering Engine Waste Heat

Energy, Exergy, Economic Performance Investigation and Multi-Objective Optimization of Reversible Heat Pump-Organic Rankine Cycle Integrating with Thermal Energy Storage

Comparison study of Trilateral Rankine Cycle, Organic Flash Cycle and basic Organic Rankine Cycle for low grade heat recovery

Influence of Alkane Working Fluid Decomposition on Supercritical Organic Rankine Cycle Systems

Research progress of the Organic Rankine Cycle working fluids thermal stability

Chemical Thermodynamics Prediction Method for the Working Fluid Thermal Stability

Review of Waste Heat Recovery for Power Generation with Organic Rankine Cycle

Analysis of the Thermodynamic Performance Limits of the Organic Rankine Cycle in Low and Medium Temperature Heat Source Applications

Testing And Thermodynamic Analysis Of Low-Grade Heat Power Generation System Using Organic Rankine Cycle

Selection and Evaluation of Dry and Isentropic Organic Working Fluids Used in Organic Rankine Cycle Based on the Turning Point on Their Saturated Vapor Curves

Thermal stability of a mixed working fluid (R513A) for organic Rankine cycle

Organic Rankine cycle performance evaluation and thermoeconomic assessment with various applications part I: Energy and exergy performance evaluation

A novel method for predicting the thermal stabilization temperature of organic Rankine cycle system working fluids based on transition state theory

Systematic Fluid Selection for Organic Rankine Cycles and Performance Analysis for a Combined High and Low Temperature Cycle

Thermodynamic analysis of working fluids: What is the highest performance of the sub- and trans-critical organic Rankine cycles?

A Study on Working Fluid Selection for Organic Rankine Cycle of Engine Waste Heat

Thermodynamic Analysis Of Organic Rankine Cycle (Orc) Systems Based On Turbine Performance Prediction

Design, improvements and applications of dual-pressure evaporation organic Rankine cycles: A review