Abstract:As an advanced connection technology for large thick-walled components, narrow gap laser welding has the advantages of small heat input and high efficiency and quality. However, porosity defects are prone to occur inside the weld due to the complex welding environment. In this study, the influence of the process parameters and pollutants such as water and oil on the porosity defect were explored. The action mechanism of water on the electron temperature and spectral intensity of the laser-induced plasma was analyzed. The results showed that the spectral intensity during narrow gap laser welding was weaker than that of flat plate butt welding. Under the optimal welding process conditions, the electron temperature during narrow gap laser self-fusion welding was calculated as 7413.3 K by the Boltzmann plot method. The electron density was 5.6714 × 1015 cm−3, conforming to the thermodynamic equilibrium state. With six groups of self-fusion welding parameters, only sporadic porosity defects were observed according to the X-ray detection. When there was water on the base metal surface, a large number of dense pores were observed on the weld surface and in the weld through X-ray inspection. Compared with the spectral data obtained under the normal process, the relative light intensity of the spectrometer in the whole band was reduced. The electron temperature decreased to the range of 6900 to 7200 K, while the electron density increased. The spectrum variation during narrow gap laser wire filling welding was basically the same as that of laser self-fusion welding. The porosity defects caused by water and oil pollutants in the laser welding could be effectively identified based on the intensity of the Fe I spectral lines.

Porosity Detection in Pulsed GTA Welding of 5A06 Al Alloy Through Spectral Analysis

Investigation of Porosity in Pulsed GTAW of Aluminum Alloys Based on Spectral and X-ray Image Analyses

Study of Inner Porosity Detection for Al-Mg Alloy in Arc Welding Through On-Line Optical Spectroscopy: Correlation and Feature Reduction

EMD-based Pulsed TIG Welding Process Porosity Defect Detection and Defect Diagnosis Using GA-SVM

A Study on Porosity in Gas Tungsten Arc Welded Aluminum Alloys Using Spectral Analysis

On-line monitor of hydrogen porosity based on arc spectral information in Al–Mg alloy pulsed gas tungsten arc welding

Features Detection of Al Alloy Porosity During GTAW Process Based on Arc Spectrum and Improved Porosity-Focus Decision Tree

Real-time Defect Detection in Pulsed GTAW of Al Alloys Through On-Line Spectroscopy

On the Mechanism and Detection of Porosity During Pulsed TIG Welding of Aluminum Alloys

On-Line Detection of Porosity in Gas Tungsten Arc Welding of Aluminum Alloy Based on Spectrum Features

Online Defect Detection of Al Alloy in Arc Welding Based on Feature Extraction of Arc Spectroscopy Signal

Porosity defect detection based on FastICA-RBF during pulsed TIG welding process

Transactions on Intelligent Welding Manufacturing: Volume III No. 3 2019

Non-destructive detection and analysis of weld defects in dissimilar pulsed GMAW and FSW joints of aluminium castings and plates through 3D X-ray computed tomography

Real-time monitoring and control of porosity defects during arc welding of aluminum alloys

Study on Porosity Defect Detection in Narrow Gap Laser Welding Based on Spectral Diagnosis

Visual Sensing and Penetration Control in Aluminum Alloy Pulsed GTA Welding

The Review of Spectrum Detection and Ultrasonic Vibration Control of Porosity Defects in Aluminum Alloy Welding

An Improved Model of Porosity Formation During Pulsed GTA Welding of Aluminum Alloys

Study on Pores in Ultrasonic‐Assisted TIG Weld of Aluminum Alloy

Quality classification model with machine learning for porosity prediction in laser welding aluminum alloys