Abstract:As a highly efficient thick plate welding resolution, narrow gap gas tungsten arc welding (NG-GTAW) is in the face of a series of problems like inter-layer defects like pores, lack of fusion, inclusion of impurity, and the sensitivity to poor sidewall fusion, which is hard to be repaired after the welding process. This study employs numerical simulation to investigate the molten pool behavior in NG-GTAW root welding. A 3D numerical model was established, where a body-fitted coordinate system was applied to simulate the electromagnetic force, and a bridge transition model was developed to investigate the wire–feed root welding. The simulated results were validated experimentally. Results show that the molten pool behavior is dominated by electromagnetic force when the welding current is relatively high, and the dynamic change of the vortex actually determines the molten pool morphology. For self-fusion welding, there are two symmetric inward vortices in the cross-section and one clockwise vortex in the longitudinal section. With the increasing welding current, the vortices in the cross-section gradually move to the arc center with a decreasing range, while the vortex in the longitudinal section moves backward. With the increasing traveling speed, the vortices in the cross-section move toward the surface of the molten pool with a decreasing range, and the horizontal component of liquid metal velocity changes in the longitudinal section. For wire–feed welding, the filling metal strengthens the downward velocity component; as a result, the vortex formation is blocked in the cross-section and is strengthened in the longitudinal section.

Effect of Swing Arc on Molten Pool Behaviors in Narrow-Gap GMAW of 5083 Al-alloy

Effect of Molten Pool Behaviors on Welding Defects in Tandem NG-GMAW Based on CFD Simulation

Molten pool behaviors and their influences on welding defects in narrow gap GMAW of 5083 Al-alloy

Effect Of Arc Swing Parameters On Narrow Gap Vertical Gma Weld Formation

Study of Weld Formation in Swing Arc Narrow Gap Vertical GMA Welding by Numerical Modeling and Experiment

Numerical Analysis of Heat Transfer and Fluid Flow in Swing Arc Narrow Gap GMA Welding

Study on Arc Characteristics and Their Influences on Weld Bead Geometry in Narrow Gap GMAW of 5083 Al-alloy

The wetting and stirring behavior of molten pool in narrow gap AMF-GTAW by numerical and experimental analysis

Effect of Rotating Arc Process on Molten Pool Control in Horizontal Welding

A Comparison of the Swing and Non-Swing Arc Behavior in Arc Ultrasonic Assisted Narrow Gap GMAW

A Swing Arc System for Narrow Gap GMA Welding

Numerical simulation on molten pool behavior of narrow gap gas tungsten arc welding

Molten Pool Behaviors in Double-Sided Pulsed GMAW of T-Joint: A Numerical Study

Stirring effect of the rotating arc on the molten pool during non-axisymmetric tungsten NG-GTAW

Numerical Evaluation of Interwire Angle Influence on Molten Pool Fluid Dynamics and Weld Defects in Tandem NG-GMAW of 5083 Aluminum Alloy

Effects of Processing Parameters on Molten Behavior, Arc Stability, and Defect Forming in Swing-Arc Narrow Gap GMA Vertical Up Welding

An Innovative Methodology in Narrow Gap GTAW for Alternating Magnetic Field with Synchronous Swing of Filler Wire and Arc

Molten pool behaviour and weld forming mechanism of tandem narrow gap vertical GMAW

Study on Short-Circuiting GMAW Pool Behavior and Microstructure of the Weld with Different Waveform Control Methods

Understanding of the Weld Pool Convection in Twin-Wire GMAW Process

Development of Swing Arc Narrow Gap GMAW Process Assisted by Swaying Wire