Abstract:Gallium nitride (GaN)-based high electron mobility transistor (HEMT) power devices have demonstrated great potential applications due to high current density, high switching speed, and low ON-resistance in comparison to the established silicon (Si)-based semiconductor devices. These superior characteristics make GaN HEMT a promising candidate for next-generation power converters. Many of the early GaN HEMTs are devices with Schottky gate, which suffer a high gate leakage and a small gate swing. By inserting an insulator under gate metal, the MIS-HEMT is highly preferred over the Schottky-gate HEMT for high-voltage power switche, owing to the suppressed gate leakage and enlarged gate swing. However, the insertion of the gate dielectric creates an additional dielectric/(Al) GaN interface that presents some great challenges to AlGaN/GaN MIS-HEMT, such as the threshold voltage (Vth) hysteresis, current collapse and the reliability of the devices. It has been reported that the poor-quality native oxide (GaOx) is detrimental to the dielectric/(Al) GaN interface quality that accounted for the Vth instability issue in the GaN based device. Meanwhile, it has been proved that in-situ plasma pretreatment is capable of removing the surface native oxide. On the other hand, low power chemical vapor deposition (LPCVD)-Si3N4 with free of plasma-induced damage, high film quality, and high thermal stability, shows great potential applications and advantages as a choice for the GaN MIS-HEMTs gate dielectric and the passivation layer. In this work, an in-situ pre-deposition plasma nitridation process is adopted to remove the native oxide and reduce surface dangling bonds prior to LPCVD-Si3N4 deposition. The LPCVD-Si3N4/GaN/AlGaN/GaN MIS-HEMT with a high-quality LPCVD-Si3N4/GaN interface is demonstrated. The fabricated MIS-HEMT exhibits a very-low Vth hysteresis of 186 mV at VG-sweep=(-30 V, +24 V), a high breakdown voltage of 881 V, with the substrate grounded. The hysteresis of our device at a higher positive end of gate sweep voltage (VG +20 V) is the best to our knowledge. Switched off after an off-state VDS stress of 400 V, the device has a dynamic on-resistance Ron only 36% larger than the static Ron.

Optimized Transport Properties of GaN MISHEMTs with Thin AlN Interlayer

Investigation of In Situ SiN as Gate Dielectric and Surface Passivation for GaN MISHEMTs

Normally-Off p-GaN Gated AlGaN/GaN MIS-HEMTs with ALD-Grown Al2O3/AlN Composite Gate Insulator

High-performance AlGaN/GaN MIS-HEMT Device Based on in Situ Plasma Nitriding and Low Power Chemical Vapor Deposition Si3N4 Gate Dielectrics

AlGaN/GaN MIS-HEMT with PECVD SiNx, SiON, SiO2 as Gate Dielectric and Passivation Layer

High-performance GaN metal–insulator–semiconductor high electron mobility transistors (MIS-HEMTs) using Sc0.2Al0.8N/SiNX as composite gate dielectric

High On/Off Current Ratio and High <i>V</i><sub>th</sub>/<i>R</i><sub>on</sub> Stability GaN MIS-HEMTs With GaN/AlN Superlattices Barrier

AlGaN/GaN MISHEMTs with AlN Gate Dielectric Grown by Thermal ALD Technique

Low Threshold Voltage Shift in AlGaN/GaN MIS-HEMTs on Si Substrate Using SiNx/SiON As Composite Gate Dielectric

High On/Off Current Ratio and High $\textit{v}_{\text{th}}$ / $\textit{r}_{\text{on}}$ Stability GaN MIS-HEMTs with GaN/AlN Superlattices Barrier

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Interface Si Donor Control to Improve Dynamic Performance of AlGaN/GaN MIS-HEMTs

Threshold Voltage Instability in III-nitride Heterostructure Metal–insulator–semiconductor High-Electron-mobility Transistors: Characterization and Interface Engineering

AlGaN/GaN MIS-HEMT With AlN Interface Protection Layer and Trench Termination Structure

Low Leakage Current and High Breakdown Field AlGaN/GaN MIS-HEMTs Using PECVD-SiNx As a Gate Dielectric

Investigation of the Interface Between LPCVD-SiNx Gate Dielectric and III-nitride for AlGaN/GaN MIS-HEMTs

Current collapse suppression in AlGaInN/GaN HEMTs with thin unintentionally doped GaN channel and AlN back barrier grown on single-crystal AlN substrate

High Performance AlGaN/GaN Power Switch with Si3N4insulation

Improving Performance and Breakdown Voltage in Normally-Off GaN Recessed Gate MIS-HEMTs Using Atomic Layer Etching and Gate Field Plate for High-Power Device Applications

Improved LPCVD-SiNx/AlGaN/GaN MIS-HEMTs by Using In-Situ MOCVD-SiNx As an Interface Sacrificial Layer

The Influence of 1nm AlN Interlayer on Properties of the Al0.3Ga0.7N/AlN/GaN HEMT Structure