Abstract:Introducing nanotwins into materials is one of the important strengthening methods to achieve the synergistic improvement of strength and ductility. The anisotropic mechanical behaviors of nanotwinned materials have been widely studied by experimental and computational methods. The dominant deformation mechanisms about dislocation slippages can be effectively switched among three modes, and controlled by twin spacing and the angle between twin boundaries (TBs) orientation and loading direction. Particularly, most of previous researches mainly focused on the deformation mechanisms during the plastic flow stage and researchers paid little attention on the anisotropic characteristics of TBs at the elastic stage which are also essential to manufacture the high-performance materials. Therefore, this study is aiming to systemically investigate the anisotropic effect of TBs both on the elastic and plastic stages within the single crystalline or polycrystalline by molecular dynamics (MD) simulations. It is revealed that, when the loading direction is parallel to twin planes, the introduction of TBs in single crystalline models will significantly affect the characteristics of atomic bond rotation and elongation dominated elastic deformation, which can alter the Poisson's ratio of materials, generate elastic-softening behavior and inhomogeneous elastic deformation. At the plastic flow stage, the deformation mechanism transforms from trans-twin dislocation slippage into the coexistence of Hard Mode I and threading dislocation slippage (Hard Mode II) when the loading direction changes from parallel to perpendicular direction with respect to TBs. However, both the elastic and plastic behaviors are less sensitive to TBs in vertical direction. Moreover, the dislocation segments at the conjunction of trans-twin dislocation play a momentous role in enhancing material strength. The results for polycrystalline models are consistent with that of single crystalline ones. These findings are expected to be beneficial for the development of high-performance nanostructured materials for structural and functional applications by strain engineering and defect regulation.

In-situ Neutron Diffraction Investigation on Twinning/detwinning Activities During Tension-Compression Load Reversal in a Twinning Induced Plasticity Steel

Tensile Failure Modes in Nanograined Metals with Nanotwinned Regions

Distribution of dislocation-twin interaction in TWIP steel under different loading modes

Transmission electron microscopy observation of a deformation twin in TWIP steel by an ex situ tensile test

A Study of Dynamic Plasticity in Austenite Stainless Steels with a Gradient Distribution of Nanoscale Twins

Orientation Dependent Twinning Behavior in a Twinning-induced Plasticity Steel Investigated by Nanoindentation

On the effect of detwinning during compressive deformation of martensitic NiTi: in situ neutron diffraction and micromechanical modeling

Dislocation Plasticity Reigns in a Traditional Twinning-Induced Plasticity Steel by in Situ Observation

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Atomic-scale Understanding of Twin Intersection Rotation and Ε-Martensite Transformation in a High Mn Twinning-Induced Plasticity Steel

In-situ TEM investigation of deformation mechanisms of twinning-induced plasticity steel

Revealing the mode and strain of reversible twinning in B19′ martensite by in situ synchrotron X-ray diffraction

Real-Time in Situ Neutron Diffraction Investigation of Phase-Specific Load Sharing in a Cold-Rolled TRIP Sheet Steel

Quasi-in-situ investigation on extension twinning behavior of extruded ZC61 alloy during dynamic compression

Investigations of dislocation-type evolution and strain hardening during mechanical twinning in Fe-22Mn-0.6C twinning-induced plasticity steel

Plasticity and Ultra-Low Stress Induced Twin Boundary Migration in Nanotwinned Cu by in Situ Nanoindentation Studies

Atomistic investigation on the anisotropic elastic and plastic responses of nanotwinned metals

Investigation of ductile damage in dual phase steel during tensile deformation by in situ X-ray computed tomography

In Situ Monitoring of Dislocation, Twinning, and Detwinning Modes in an Extruded Magnesium Alloy under Cyclic Loading Conditions

The mechanism of twin thickening and the elastic strain state of TWIP steel nanotwins

Atomistic Simulation for Deforming Complex Alloys with Application Toward TWIP Steel and Associated Physical Insights