Abstract:In the selective laser melting process, metal powder melted by the laser heat source generates large instantaneous energy, resulting in transient high temperature and complex stress distribution. Different temperature gradients and anisotropy finally determine the microstructure after melting and affect the build quality and mechanical properties as a result. It is important to monitor and investigate the temperature and stress distribution evolution. Due to the difficulties in online monitoring, finite element methods (FEM) are used to simulate and predict the building process in real time. In this paper, a thermo-mechanical coupled FEM model is developed to predict the thermal behaviors of the melt pool by using Gaussian moving heat source. The model could simulate the shapes of the melt pool, distributions of temperature and stress under different process parameters through FEM. The influences of scanning speed, laser power, and spot diameter on the distribution of the melt pool temperature and stress are investigated in the SLM process of Al6063, which is widely applied in aerospace, transportation, construction and other fields due to its good corrosion resistance, sufficient strength and excellent process performance. Based on transient analysis, the relationships are identified among these process parameters and the melt pool morphology, distribution of temperature and thermal stress. It is shown that the maximum temperature at the center point of the scanning tracks will gradually increase with the increment of laser power under the effect of thermal accumulation and heat conduction, as the preceded scanning will preheat the subsequent scanning tracks. It is recommended that the parameters with optimized laser power (P = 175–200 W), scanning speed (v = 200–300 mm/s) and spot diameter (D = 0.1–0.15 mm) of aluminum alloy powder can produce a high building quality of the SLM parts under the pre-set conditions.

Modeling of the Thermal Physical Process and Study on the Reliability of Linear Energy Density for Selective Laser Melting

Finite Element Analysis of Thermal Behavior and Experimental Investigation of Ti6Al4V in Selective Laser Melting

PARTICLE SCALE NUMERICAL MODELLING OF HEAT TRANSFER AND MELT POOL DYNAMICS IN SELECTIVE LASER MELTING

Thermo-Fluid-Dynamic Modeling of the Melt Pool During Selective Laser Melting for AZ91D Magnesium Alloy

Advances in Thermal Modeling of Selective Laser Sintering of Metal Powders

A Thermo-Metallurgical-mechanical Model for Selective Laser Melting of Ti6Al4V

Modeling and numerical studies of selective laser melting: Multiphase flow, solidification and heat transfer

A new heat source model for selective laser melting simulations based on energy distribution on the powder layer and the surface of substrate

Thermal behavior in single track during selective laser melting of AlSi10Mg powder

Numerical Simulation and Parametric Analysis of Selective Laser Melting Process of AlSi10Mg Powder

A Powder Shrinkage Model for Describing Real Layer Thickness During Selective Laser Melting Process

Powder-scale Multi-Physics Modeling of Multi-Layer Multi-Track Selective Laser Melting with Sharp Interface Capturing Method

Thermal Dynamic Behavior During Selective Laser Melting of K418 Superalloy: Numerical Simulation and Experimental Verification

Investigation into the shrinkage in Z-direction of components manufactured by selective laser melting (SLM)

Process parameter optimization and mechanical properties for selective laser melting of AlSi10Mg alloy

Effects of Processing Parameters on the Temperature Field of Selective Laser Melting Metal Powder

The Thermo-Mechanical Coupling Effect in Selective Laser Melting of Aluminum Alloy Powder

Investigation of SLM Process in Terms of Temperature Distribution and Melting Pool Size: Modeling and Experimental Approaches

Coupling Analysis on Microstructure and Residual Stress in Selective Laser Melting (SLM) with Varying Key Process Parameters

Understanding processing parameters affecting residual stress in selective laser melting of Inconel 718 through numerical modeling

Simulation of Temperature Field for Optimization of Processing Parameters of Selective Laser Melting Metal Powders