Influence of BN microstructure on oxidation of SiC/BN/SiC composites
Victoria L. Christensen,Oriol Gavalda‐Diaz,Ryan Skillett,Calvin Prentice,Matthew R. Begley,Frank W. Zok
DOI: https://doi.org/10.1111/jace.20230
IF: 4.186
2024-10-25
Journal of the American Ceramic Society
Abstract:This study investigates the effects of boron nitride (BN) coating characteristics on the subsurface oxidation behavior of SiC/SiC composites in high‐temperature, water‐rich environments. Three types of coatings were examined: a crystalline stoichiometric BN, an amorphous BN, and a Si‐doped amorphous BN, the latter two containing 5–10 at% of oxygen and carbon. High‐resolution imaging and chemical analysis techniques were used to probe microstructural changes after oxidation at 1000°C for 1 or 12 h in flowing 20 vol% H2O, focusing on effects of coating thickness. Complementary chemical thermodynamic calculations and models for reaction‐ and transport‐controlled recession were used to interpret the experimental findings. Crystalline BN coatings produce open recession channels without forming borosilicate glass, a consequence of carbothermal reduction arising from C/CO produced through concomitant SiC oxidation. The combination of active oxidation and the relatively thick coatings in this system (ca. 1 μm) leads to a recession rate controlled by the intrinsic BN volatilization rate rather than the rate of gas transport. In contrast, amorphous coatings, both undoped and Si‐doped, readily oxidize to form borosilicate glasses that replace the BN. Broadly, the recession lengths increase with coating thickness. In the early stages, while the glass is boria‐rich and thus permeable to environmental oxidants, recession is controlled by the BN oxidation rate. As boria volatilizes, the silica concentration in the glass increases, eventually reaching the saturation limit and precipitating solid silica on the internal surfaces, essentially arresting further recession.
materials science, ceramics