Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Improvement on Durability and Thermal Cycle Performance for Solid Oxide Fuel Cell Stack with External Manifold Structure

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

High and durable performance of an external-manifold designed reversible solid oxide cell stack

Long-term thermo-mechanical performance evolution of a 15-cell solid oxide fuel cell stack

Degradation analysis of commercial interconnect materials for solid oxide fuel cells in stacks operated up to 18000 hours

Mechanisms of performance degradation induced by thermal cycling in solid oxide fuel cell stacks with flat-tube anode-supported cells based on double-sided cathodes

Long-Term Operation and Post Analysis of a Stack with Methane Fuel

Flow uniformity analysis and optimization of a 60-cell external manifold solid oxide cell stack with bottom-accesses

Thermal Stress in Full-Size Solid Oxide Fuel Cell Stacks by Multi-Physics Modeling

Understanding performance difference in the scale-up of flat-chip solid oxide fuel cell: An experimental and numerical study

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Degradation behavior under alternating constant-current/constant-voltage discharge for flat-tube solid oxide fuel cells inside stack

Performance and degradation of an SOEC stack with different cell components

Numerical Investigation of Air Flow Characteristics for a Compact 5 × 10 Array Tubular Segmented-in-series Solid Oxide Fuel Cell Stack

The Progress on Research and Development of Tubular Solid Oxide Fuel Cell Stacks

Numerical Study on Effects of Structure Parameters and Operating Conditions on the Micro-Tubular SOFC Stack Performance

Degradation Mechanisms of Solid Oxide Fuel Cells under Various Thermal Cycling Conditions

The Recent Progress of Planar Solid Oxide Fuel Cell Stack

Stability Study on a Novel Micro Structure Configuration of Cathode Contact Layer for Solid Oxide Fuel Cell Stack

Experimental investigation of temperature distribution in solid oxide fuel cells