Abstract:Cu-SSZ-13 zeolite has attracted great interest owing to its extraordinary performance in the selective catalytic reduction of NOx with NH3 (NH3-SCR); however, the high expense in the costly templates for synthesizing SSZ-13 remains a serious obstacle for its application in large scale, which exacts alternative methods to get SSZ-13 of high performance in NH3-SCR at reduced cost. In this work, a series of methods, including the interzeolite conversion from X and Y zeolites (to get SZ-XC and SZ-YC, respectively) and the assistance with seed crystal and fluorine ion (to get SZ-S and SZ-F, respectively), were used to synthesize the Al-rich Cu-SSZ-13 zeolites; the influence of preparation method on the Al distribution, hydrothermal stability and catalytic performance of Cu-SSZ-13 in NH3-SCR was then comparatively investigated. The results indicate that the Cu-SSZ-13 zeolites prepared by various methods are also rather different in the content of paired Al and active Cu2+-2Al species, following the order of SZ-F > SZ-S > SZ-YC > SZ-XC; a positive correlation is observed between the catalytic activity in NH3-SCR and the content of α-Cu2+-2Al species determined by the electron spinning resonance. In particular, the Cu-SSZ-13 zeolite prepared by using fluoride as an assistant (Cu-SZ-F) has much higher fraction of paired Al and active α-Cu2+-2Al species and thereby exhibits better catalytic performance in NH3-SCR, with an NO conversion of nearly 80% at 200 °C under a gaseous hourly space velocity (GHSV) of 240,000 h−1. Moreover, the Cu-SSZ-13 zeolite prepared by the fluoride assistance method also displays less silanol defects and greater hydrothermal stability, showing enormous potential as a practicable catalyst of low cost in the elimination of NOx by NH3-SCR.

Growth of Cu/SSZ-13 on SiC for selective catalytic reduction of NO with NH 3

Cu-SSZ-13 zeolite–metal oxide hybrid catalysts with enhanced SO2-tolerance in the NH3-SCR of NOx

Crystal growth regulation of Cu-SSZ-13 zeolites for effective catalytic reduction of NOx from automotive exhausts

A comparison of Al-rich Cu-SSZ-13 zeolites synthesized by different methods in their Al distribution, hydrothermal stability and catalytic performance in the selective catalytic reduction of NOx with NH3

Atomic layer deposition of silica to improve the high-temperature hydrothermal stability of Cu-SSZ-13 for NH3 SCR of NOx

Regulation of Al distributions and Cu2+ locations in SSZ-13 zeolites for NH3-SCR of NO by different alkali metal cations

MnOx-CeO2 Supported on Cu-SSZ-13: A Novel SCR Catalyst in a Wide Temperature Range

Synthesis of Cu-SSZ-13 from Zeolite Analcime Derived from Solid Waste and Natural Minerals for Selective Catalytic Reduction of NO

Effects of Cu species in Cu-SSZ-13 zeolites on the performance of NO x reduction reactions

In-situ One-Pot Synthesis of Ti/Cu-SSZ-13 Catalysts with Highly Efficient NH3-SCR Catalytic Performance as Well as Superior H2O/SO2 Tolerability

Ceria Supported on Sulfated Zirconia As A Superacid Catalyst for Selective Catalytic Reduction of No with Nh3

Tuning the high-temperature hydrothermal stability of one-pot derived Cu-SSZ-13 in the presence of SO 2 for selective catalytic reduction of NO x by ammonia

High Activity and Wide Temperature Window of Fe‐Cu‐SSZ‐13 in the Selective Catalytic Reduction of NO with Ammonia

Zeolite and Related Porous Materials for Energy in New Era of Carbon Peak and Carbon Neutralization

Interface Induced by Hydrothermal Aging Boosts the Low-Temperature Activity of Cu-SSZ-13 for Selective Catalytic Reduction of NOx

La ions-enhanced NH3-SCR performance over Cu-SSZ-13 catalysts

Engineering CeZrOx-Cu/SSZ-13 coupled catalysts to synergistically enhance the low-temperature NH3-SCR activity

One-pot synthesis of Fe/Cu-SSZ-13 catalyst and its highly efficient performance for the selective catalytic reduction of nitrogen oxide with ammonia

Effects of Post-Treatment Method and Na Co-Cation on the Hydrothermal Stability of Cu–SSZ-13 Catalyst for the Selective Catalytic Reduction of NO with NH3

In-Situ Synthesis of Cu-SSZ-13 Catalyst: Effect of Crystallization Time on NH3-SCR Performance

Optimization of isolated copper species on the NH 3 -SCR performance over Cu/SSZ-39 modified by ammonia water