Abstract:The high-speed camera was used to observe the behavior of the melt flow in the highspeed laser welding process. The humping formation and the effect of the welding speed on the humping tendency have been discussed, and the suppression methods of humping have also been studied. The results show that the humping formation undergoes three stages: nucleation stage, growth up stage and solidification stage. During the nucleation stage, the two side streams flow around the keyhole and subsequently converge at the rear of the keyhole. Finally, the wave motion of the liquid metal, which means the nucleus of the humping, is formed in the converging process. During the growth up stage, the valley of the wave is given priority to solidify, which prevents the peak liquid metal from flowing to the rear of the molten pool. The peak of the wave is filled to expand by the front liquid metal. During the solidification stage, the grown-up peak solidifies from the bottom to top, which lifts the solid-liquid interface upward, declines the contact angle, and makes it difficult for the peak liquid metal to spread. With increasing the welding speed, the distance between the converging position at the rear of the keyhole and the laser beam increases, the temperature of the liquid metal at the rear of the keyhole decreases, the surface tension goes up, the peak liquid metal is hard to spread, the humping is apt to nucleate, and humping tendency is increased. Adopting the laser with small spot diameter is helpful to shorten the distance between convergence position and laser beam, and using the trailing beam of the dual beam laser is propitious to increase the temperature of the liquid metal in the rear of the keyhole. These two approaches are effective in decreasing the surface tension, and suppressing the nucleation of humping.

Investigation of the Humping Formation in the High Power and High Speed Laser Welding

Humping Formation and Suppression in High-Speed Laser Welding

INVESTIGATION OF HUMPING FORMATION BASED ON MELT FLOW ANALYSIS IN HIGH-SPEED LASER WELDING PROCESS

Understanding Humping Formation Based on Keyhole and Molten Pool Behaviour During High Speed Laser Welding of Thin Sheets

Transport Phenomena and the Associated Humping Formation in Laser Welding

Study of Humping Tendency and Affecting Factors in High Speed Laser Welding of Stainless Steel Sheet

Understanding root humping in high-power laser welding of stainless steels: a combination approach

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

The Effect of Humping on Residual Stress and Distortion in High-Speed Laser Welding Using Coupled CFD-FEM Model

Experimental and Numerical Analysis of Molten Pool and Keyhole Profile During High-Power Deep-Penetration Laser Welding

Investigation of Weld Root Defects in High-Power Full-Penetration Laser Welding of High-Strength Steel

Formation mechanism of hump defects in high-speed laser wire additive manufacturing

Understanding of Humping Formation and Suppression Mechanisms Using the Numerical Simulation

Simulation Study on Weld Formation in Full Penetration Laser + MIG Hybrid Welding of Copper Alloy

Influencing mechanism of high speed on the droplet transfer and process stability during high-power laser-arc hybrid welding

Investigation on the Weld Bead Profile Transformation with the Keyhole and Molten Pool Dynamic Behavior Simulation in High Power Laser Welding

Influencing of Molten Pool Dynamic Behavior on the Weld Formation during the Laser‐Arc Hybrid Welding of 12 mm Thick Steel

Effects of Solidification on Flow Dynamics: A Novel Comprehension of Defects Formation in Laser Penetration Welding

Monitoring of High-Speed Laser Welding Process Based on Vapor Plume

Role of Welding Speed on Keyhole-Induced Porosity Formation Based on Experimental and Numerical Study in Fiber Laser Welding of Al Alloy

Study on Root Hump Formation Mechanism in Full Penetration Laser Welding with Backing Gas for Aluminum Alloy