Abstract:The high-speed camera was used to observe the behavior of the melt flow in the highspeed laser welding process. The humping formation and the effect of the welding speed on the humping tendency have been discussed, and the suppression methods of humping have also been studied. The results show that the humping formation undergoes three stages: nucleation stage, growth up stage and solidification stage. During the nucleation stage, the two side streams flow around the keyhole and subsequently converge at the rear of the keyhole. Finally, the wave motion of the liquid metal, which means the nucleus of the humping, is formed in the converging process. During the growth up stage, the valley of the wave is given priority to solidify, which prevents the peak liquid metal from flowing to the rear of the molten pool. The peak of the wave is filled to expand by the front liquid metal. During the solidification stage, the grown-up peak solidifies from the bottom to top, which lifts the solid-liquid interface upward, declines the contact angle, and makes it difficult for the peak liquid metal to spread. With increasing the welding speed, the distance between the converging position at the rear of the keyhole and the laser beam increases, the temperature of the liquid metal at the rear of the keyhole decreases, the surface tension goes up, the peak liquid metal is hard to spread, the humping is apt to nucleate, and humping tendency is increased. Adopting the laser with small spot diameter is helpful to shorten the distance between convergence position and laser beam, and using the trailing beam of the dual beam laser is propitious to increase the temperature of the liquid metal in the rear of the keyhole. These two approaches are effective in decreasing the surface tension, and suppressing the nucleation of humping.

The Effect of Humping on Residual Stress and Distortion in High-Speed Laser Welding Using Coupled CFD-FEM Model

Investigation of the Humping Formation in the High Power and High Speed Laser Welding

Transport Phenomena and the Associated Humping Formation in Laser Welding

Humping Formation and Suppression in High-Speed Laser Welding

Effect of collapse and hump on thermomechanical behavior in high-power laser welding of 16-mm marine steel EH40

INVESTIGATION OF HUMPING FORMATION BASED ON MELT FLOW ANALYSIS IN HIGH-SPEED LASER WELDING PROCESS

Formation mechanism of hump defects in high-speed laser wire additive manufacturing

Numerical Analysis of Welding Defects in the Horizontal Position Laser-Metal Inert Gas Hybrid Fillet Welding

Numerical simulation of residual stress and deformation on laser welding of "grooved-coat" structure

Understanding Humping Formation Based on Keyhole and Molten Pool Behaviour During High Speed Laser Welding of Thin Sheets

Modeling of transport phenomena in hybrid laser-MIG keyhole welding

Understanding root humping in high-power laser welding of stainless steels: a combination approach

Investigation on the Weld Bead Profile Transformation with the Keyhole and Molten Pool Dynamic Behavior Simulation in High Power Laser Welding

Simulation and Modeling of Shielding Gas on the Welding Defects in the Fiber Laser Keyhole Welding

Numerical and Experimental Investigation of Thermal Field and Residual Stress in Laser-Mig Hybrid Welded NV E690 Steel Plates

Influencing of Molten Pool Dynamic Behavior on the Weld Formation during the Laser‐Arc Hybrid Welding of 12 mm Thick Steel

A Three-Dimensional Numerical Simulation Model for Weld Characteristics Analysis in Fiber Laser Keyhole Welding

Numerical Simulation and Experimental Investigation of Residual Stresses and Distortions in Pulsed Laser Welding of Hastelloy C-276 Thin Sheets

3d Multiphysical Modelling Of Fluid Dynamics And Mass Transfer In Laser Welding Of Dissimilar Materials

Modeling the Transport Phenomena During Hybrid Laser-MIG Welding Process

Physics of humping formation in laser powder bed fusion