Abstract:Prior to practical service, hot-section components (e.g. airfoils and vanes) of a gas turbine engine are necessarily coated by a protective metallic coating (such as aluminidi diffusion coating, modified aluminide coating and MCrAlY overlay etc.) to resist high temperature oxidation and hot corrosion. Among the modified aluminide coatings, the coating with Pt-modification has attracted great attention and is widely used in applications requiring high reliability and extended service life since it possesses superior oxidation/corrosion resistance at high temperature. The presence of Pt in aluminide coating is favorable for increasing bonding strength of oxide scale, enlarging phase region of beta 3-NiAI and confining detrimental effect of sulphur etc. Although Pt-modification has exhibited visible benefits for acquiring better high-temperature performance, it is far from satisfaction to develop an ideal aluminide diffusion coating. Reactive elements such as Y, Hf, Zr or their oxides have been employed to modify the nickel aluminide coating system, with an aim to further improve scale adhesion and promote exclusive formation of alpha-Al2O3 simultaneously. In this work, a Zr-doped PtAl2+(Ni, Pt)Al dual-phase aluminide coating was prepared on a Ni-based single crystal superalloy by co-deposition of Pt-Zr through electroplating and sub-sequent aluminization treatments The coating was mainly composed of three layers: the outmost layer consisted of double phases with PtAl2 particles dispersed in beta-(Ni, Pt)Al domain, while the interlayer comprised beta-(Ni, Pt)Al with small amount of Cr-precipitates, and the bottom layer was an inter-diffusion zone (IDZ). Zirconium was mainly distributed inside beta-(Ni, Pt)Al solid solution in both the outmost layer and the interlayer. Compared with normal PtAl2+(Ni, Pt)Al dual-phase coating, the hot corrosion behavior of the Zr-doped PtAl2 + (Ni, Pt)Al coating was assessed in a salt mixture of Na2SO4/NaCI (75:25, mass ratio) at 850 degrees C in static air. The results indicated that the Zr-doped PtAl2+(Ni, Pt)Al dual-phase coating exhibited superior hot corrosion resistance since Zr was confirmed able to capture and fix S and CI to diminish their detrimental effects. Meanwhile, a pre-oxidation treatment did not effectively improve the overall hot corrosion resistance of normal PtAl2+(Ni, Pt)Al coating because the thin alumina scale formed during pre-oxidation was unable to prohibit the sustained inward-invasion of the mixed salt.

Preparation and Enhanced Hot Corrosion Resistance of a Zr-Doped PtAl2+(Ni, Pt)Al Dual-Phase Coating

(Invited) Benefits of Zr Addition on Hot Corrosion and Isothermal Oxidation Resistance of Single-Phase (ni,pt) Al Coatings

A Zr-doped single-phase Pt-modified aluminide coating and the enhanced hot corrosion resistance

Benefits of Zr Addition to Oxidation Resistance of a Single-Phase (ni,pt)al Coating at 1373 K

Increasing hot corrosion resistance of β-(Ni, Pt)Al coating by replacing Pt partially with Zr

Oxidation Property and Failure Mechanism of A Single Phase Ptal2 Coating

Effect of Isothermal Oxidation on the Structural Properties of (Ni,Pt)Al Coatings Doped with Zr at 1150 °C

High-temperature Corrosion Behaviour of Pt-modified Aluminide Coating with Solid NaCl Deposit in O2 + 10 Vol% H2O and the Influence of Pre-Oxidation Treatment

Hot Corrosion and Cyclic Oxidation Performance of a Ptal2-Dispersed (ni,pt)al Coating Prepared by Low-Activity High-Temperature Aluminizing

Cyclic oxidation behavior of Pt modified NiCoCrAlYHfZr + AlNiY coating on a Ni-based single crystal superalloy

High-Temperature Corrosion Behaviour of Pt-Modified Aluminide Coating under the Effect of Nacl Plus Water Vapour and the Influence of Pre-Oxidation Treatment

Enhancing the High-Temperature Corrosion Resistance of HVOF-sprayed NiCoCrAlY Coating in Marine Environment by Pt Modification and Pre-Oxidation

Hot Corrosion Behaviour of Single-Phase Platinum-Modified Aluminide Coatings: Effect of Pt Content and Pre-Oxidation

Tuning the secondary reaction zone between PtAl coating and nickel based single crystal superalloy during high-temperature oxidation through regulating aluminizing time

Preparation and Enhanced Oxidation Performance of a Hf-doped Single-Phase Pt-modified Aluminide Coating

Oxidation Performance and Interdiffusion Behavior of a Pt-Modified Aluminide Coating with Pre-deposition of Ni

Effect of Nickel Aluminide Microcrystalline Coating on High-Temperature Oxidation Behavior of NiAl-33.5%Cr-0.5%Zr Alloy

High-temperature performance of Pt-modified Ni-20Co-28Cr-10Al-0.5Y coating: Formation mechanism of Pt-rich overlayer and its effect on thermally grown oxide failure

Improving Cyclic Oxidation Resistance of Ni3Al-based Single Crystal Superalloy with Low-Diffusion Platinum-Modified Aluminide Coating

Effect of Pt modification on hot corrosion resistance of NiCrAlYSi+AlY coating at 900 °C

Preparation and Enhanced Isothermal Oxidation Resistance of a Low Diffusivity NiRePtAl Single-Phase Coating