Abstract:Time-to-digital converters (TDCs) act as a core component in many timing-critical systems. Tapped delay line is the most widely used style for the field-programmable gate-array (FPGA)-based TDCs, but it suffers from several intractable problems such as poor nonlinearity and long delay-line occupation. Recently, a new ring-oscillator-based Vernier TDC circuit using carry chains was demonstrated to have much smaller nonlinearity with a much shorter delay line. Since the used delay line is not compensated, the timing jitter increases (or the precision degrades) remarkably when the oscillation number is large. This would incur undesirable lower resolution selection to maintain acceptable precision. In this article, a novel bidirectional-operating Vernier delay line structure is proposed to reduce the required oscillation number during the fine time measurement. Traditionally, for the Vernier delay line, the fast signal propagates along the slow delay line, while the slow signal propagates along the fast delay line, to which we call the normal Vernier delay line. The new structure proposes two parallelized Vernier delay line, consisting of one normal Vernier delay line and another abnormal Vernier delay line. The term "abnormal" refers to that the fast and slow signals are unusually fed to the fast and slow delay lines, respectively. A prototype TDC circuit based on this new method was implemented on a Stratix III FPGA. Test results demonstrate that by adopting the proposed novel circuit architecture, both the resolution and the root-mean-square error can be improved from the 30–40-ps level to the 20–30-ps level.

A Highly Linear 5gs/s Voltage-to-time Converter for Time-Based Analog-to-digital Converters

A Highly Linear Voltage-to-Time Converter with Variable Conversion Gain for Time-Based ADCs

A 1gs/s Highly Linear Voltage-to-Time Converter with Rail-to-Rail Input Range for Time Domain ADCs

Design Of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter For Modern Fpgas At 10mhz

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A Low-Power Inverter-Based ΣΔ Analog-to-digital Converter for Audio Applications

A 5-Bit, 87-Fs Step, Constant-Slope, Charge-Sharing-Based Encoding Digital-to-Time Converter in 130nm CMOS

A 10-Bit 563-Fs Step Constant-Slope Digital-to-Time Converter in 40-Nm CMOS with Nonlinearity Cancellation and Range Extension Techniques

Design of a High Speed Low Power Time-to-Digital Converter Based on Multi-stage Amplification Structure

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

Time-Encoding Analog-to-Digital Converters: Bridging the Analog Gap to Advanced Digital CMOS-Part 1: Basic Principles

A 500-MS/s 9-Bit Time-Domain ADC Using a Nonbinary Successive Approximation TDC

A 150 MS/s 10-Bit CMOS Pipelined Subranging ADC with Time Constant Reduction Technique.

A Low-power Synthesizable Time-to-Digital Converter Using Amplification to Overcome Mismatch

An 8-Bit 5-Gs/s Single-Channel Hybrid ADC with a $\lambda$ /4 Transmission Line Based Time Quantizer

A High-Linearity Vernier Time-to-Digital Converter on FPGAs With Improved Resolution Using Bidirectional-Operating Vernier Delay Lines

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A High-Resolution Time-To-Digital Converter Based on Parallel Delay Elements

High Speed Current Domain CMOS D/A Converter Design

A Three-Step Multi-Resolution Time-to-Digital Converter.