Abstract:The pile foundation under a high-speed railway (HSR) not only bears the self-weight of the superstructure, but also bears a long-term vertical periodic load during its service. In this study, a large-scale vertical dynamic load test and particle flow numerical simulation method were adopted to investigate the axial cyclic performances of open piles in sand. The results from the dynamic test show that under a dynamic load with cyclic load ratios of 0.1 and 0.2, the surface displacement of the pile decays rapidly as the pile distance increases. Moreover, the higher the vibration amplitude and frequency, the larger the surface displacement. The influence range of the soil around the pile is approximately six times of the pile diameter. It is also found that the external frictional resistance of the upper part of the pile decreases, whereas that of the middle part increases. In addition, the internal friction resistance of the lower part of the pile decreases and gradually stabilizes after approximately 200 cycles. The simulation results show that the influence range of the pile on the surrounding soil is approximately 5–8 times the diameter of the pile under the action of dynamic loading; the vertical displacement of the pile mainly occurs at the beginning of the cycles. The total settlement of the pile foundation increases with an increase in the cyclic load ratio. With an increase in the cycle period, the friction resistance values on the outside of the pile and middle part significantly decrease and increase, respectively. After 10 cycles, the resistance gradually stabilizes, and no evident changes in the internal friction resistance of the pile are observed.

Experimental Study on the Behavior of X-Section Pile Subjected to Cyclic Axial Load in Sand

Advanced laboratory investigation of axial cyclic loading in silica sands

Model test of vertical bearing characteristics of X-section pile under cyclic loading

Performance of laterally loaded H-piles in sand

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Field Tests on Bearing Characteristics of X-Section Pile Composite Foundation

Numerical analysis of X-section cast-in-place concrete pile groups under vertical load

Model Test on Vertical Bearing Capacity of X-section Concrete Pile Raft Foundation in Silica Sand

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Performance of X-Section Concrete Pile Group in Coral Sand under Vertical Loading

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Full Scale Model Tests on Vertical Bearing Characteristics of Cast-in-place X-section Piles

Field Study on Load Transfer Mechanism of XCC Pile Raft Foundation

Experimental and Analytical Study of X-Section Cast-In-Place Concrete Pile Installation Effect

Model Test of Vertical Bearing Capacity of Cast-in-situ X-shaped Concrete Piles

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Model tests of single pile vertical cyclic loading in calcareous sand

Experimental Investigation on a Single Stiff Pile Subjected to Long-Term Axial Cyclic Loading