Abstract:To study the pile-forming mechanism and bearing deformation characteristics of continuous flight auger (CFA) piles, a series of procedures, including helical drilling, pulling up/grouting, and inserting cage/pile forming, were simulated in clay-sand double-layer foundations by a homemade model drilling machine system in laboratory model tests. The effects of two different pile-forming methods on the load transfer and bearing characteristics of the piles were investigated by performing a model test comparison of CFA piles and bored piles. The experimental results show that there exist a soil improvement effect around the pile and a diameter expansion effect during the drilling process and grouting process for the CFA pile, which can effectively improve the lateral friction resistance of the pile. Compared with the bored pile, the pile diameter in the middle of the CFA pile increased by 19%, and the total lateral friction resistance of the CFA pile increased by 9.1% at a high load (1500 N). The comparative results of the model tests show that the bearing capacity of a single CFA pile increased by 50.0% and that the total settlement decreased by 40.5%. The results of the in situ test piles show that the load-settlement curves of the two pile types are similar under low-medium loads and that the lateral friction resistance of the CFA pile under high loads is better developed, which is relatively consistent with the model test results.

Model Test of Vertical Bearing Capacity of Cast-in-situ X-shaped Concrete Piles

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Full Scale Model Tests on Vertical Bearing Characteristics of Cast-in-place X-section Piles

Test on Vertical Behavior of Cast-in-situ X-shaped Concrete Pile and Its Ultimate Bearing Capacity Prediction

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

A test on base bearing capacity of static drill rooted nodular pile

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles

Analysis of Bearing Performance of Composite Foundation with Cast-in-situ Concrete Thin-Wall Pipe Piles under Vertical Loads

Analysis of Ultimate Bearing Capacity of X-section Cast-in-place Concrete Pile Composite Foundation under Rigid Load

Numerical analysis of X-section cast-in-place concrete pile groups under vertical load

Model Test on Vertical Bearing Capacity of X-section Concrete Pile Raft Foundation in Silica Sand

Field Test on the Influence of the Cemented Soil Around the Pile on the Lateral Bearing Capacity of Pile Foundation

Mechanical Property for Cast-in-situ X-shaped Concrete Pile of Reinforced Soft Roadbed

RESEARCH ON INFLUENCE OF SOIL CORE ON BEARING CHARACTER OF LARGE-DIAMETER TUBULAR PILE USING CAST-IN-SITU CONCRETE

Field Tests on Bearing Characteristics of X-Section Pile Composite Foundation

Experimental Study on the Behavior of X-Section Pile Subjected to Cyclic Axial Load in Sand