Abstract:The epitaxial growth of anatase (001) films deposited by pulsed laser deposition (PLD) and molecular beam epitaxy (MBE) on SrTiO3 (001) (STO) single crystals has been studied using X-ray diffraction and surface sensitivity UHV techniques. The evolution of the strain represented by the microstrain and the change of the in-plane and out-of-plane lattice parameters with film growth temperature, the effect of the annealing temperature and the influence of the oxygen content of the film have been investigated.The out-of-plane lattice strain shows a compressive (-0.2%) or expansive (+0.3%) behavior, in the range 600-900$^\circ$C, for temperatures below or above 700$^\circ$C, respectively. The in-plane lattice parameters, as well as the cell volume of the film, remain under compression over the entire temperature range explored.PLD films grow into square islands that align with the surface lattice directions of the STO substrate. The maximum size of these islands is reached at growth temperatures close to 875-925$^\circ$C. Film annealing at temperatures of 800$^\circ$C or higher melts the islands into flat terraces. Larger terraces are reached at high annealing temperatures of 925$^\circ$C for extended periods of 12 hours. This procedure allows flat surface terrace sizes of up to 650 nm to be achieved.The crystalline quality achieved in anatase films prepared by PLD or MBE growth methods is similar. The two-step anatase growth process used during the synthesis of the films with both methods: film growth and post-annealing treatment in oxygen or air at ambient pressure, using temperature and time as key parameters, allows to control the surface terrace size and stoichiometry of the films, as well as the anatase/rutile intermixing rates at sufficiently high temperatures. This growth process could allow the substitution of their equivalent single crystals. The range of applicability of these films would include their use as structural and electronic model systems, or in harsh experimental conditions due to their low production cost.

Heteroepitaxial Growth and Interface Structure of Pyrochlore (ca,ti) 2 (nb,ti) 2 O 7 Thin Films on (1 1 0) NdGaO 3 Substrates

Synthesis of epitaxial magnetic pyrochlore heterojunctions

Epitaxial growth and stoichiometry control of pyrochlore thin films

Microstructures and Surface Step-Induced Antiphase Boundaries in Epitaxial Ferroelectric Ba0.6sr0.4tio3 Thin Film on Mgo

Epitaxial Growth of Pbtio3 Thin Film on (110)ndgao3 Substrate by Metalorganic Chemical Vapor Deposition

Epitaxial growth of Bi$_2$Pt$_2$O$_7$ pyrochlore

Interface Structures and Epitaxial Behavior of Ferroelectric (ba,sr)tio3 Thin Films

The Growth and Phase Transitions of Epitaxial Pb(Zr0.95ti0.05)O-3 Thin Films Prepared by Sputter Deposition Combined with Post-Annealing on Srtio3(1 0 0)

Synthesis, crystal growth and characterization of the pyrochlore Er2Ti2O7

In situ growth and properties of epitaxial TlBa/sub 2/CaCu/sub 2/O/sub 7/ and TlBa/sub 2/(Ca/sub 1-x/Y/sub x/)Cu/sub 2/O/sub 7/ thin films

Heteroepitaxial growth of anatase (0 0 1) films on SrTiO3 (0 0 1) by PLD and MBE

Microstructures and Growth Mechanisms of the Polycrystalline CaBaCo2 O5+δ Thin Films Grown on (001)laalo3 Substrates

Synthesis and characterization of dense Gd2Ti2O7 pyrochlore thin films deposited using RF magnetron sputtering

Interfacial Oxygen Octahedral Coupling Driven Robust Ferroelectricity in Epitaxial Na0.5Bi0.5TiO3 Thin Films

Heteroepitaxial growth of TiN film on MgO (100) by reactive magnetron sputtering

Self-Patterned Nano Structures in Structurally Gradient Epitaxial La0.5ba0.5coo3 Films

Defect Engineering in Epitaxial Thin Films of the Pyrochlore Frustrated Magnet Tb 2 Ti 2 O 7

The pyrochlore Ho2Ti2O7: Synthesis, crystal growth and stoichiometry

Epitaxial growth of ferroelectric PbTiO3 thin films by metalorganic chemical vapor deposition

Interface Modulated Structure of Highly Epitaxial (pb,sr)tio3 Thin Films on (001) MgO

X-Ray Analysis Of Epitaxial Pbtio3 Thin Film Grown On An (001)Srtio3 Substrate By Metal-Organic Chemical Vapour Deposition