Abstract:In this paper, the equivalent creep strain distributions ahead of crack tips in SEN(B), SEN(T) and M(T) specimens with different in-plane and out-of-plane constraints were calculated by extensive finite element analyses, and the creep crack growth (CCG) rates of these specimens were simulated over a wide range of C* by using stress dependent creep ductility and strain rate model in a ductility exhaustion based damage model. The capability and applicability of the constraint parameter Ac based on crack-tip equivalent creep strain for characterizing both in-plane and out-of-plane creep crack-tip constraints and establishing a unified correlation with CCG rate of a steel were investigated. The results show that with increasing constraints, the CCG rate increases, and the effect of out-of-plane constraint on CCG rate is more obvious than that of in-plane constraint. The CCG rate of high constraint specimen geometry (such as SEN(B)) is more sensitive to the out-of-plane and in-plane constraints than that of low constraint specimen geometry (such as M(T)). The parameter Ac is a unified characterization parameter of in-plane and out-of-plane creep constraints for the different specimen geometries. Base on the parameter Ac, the unified correlation formulas of in-plane and out-of-plane constraints with CCG rate of the steel have been obtained, and they are independent on the choices of the standard specimen. The unified correlation formulas may be used in constraint-dependent CCG life assessments of high-temperature components (such as pressure vessels and pipes) with any in-plane and out-of-plane constraint levels.

Unified Constraint Parameter Solutions for Axial and Circumferential Surface Cracks in Pressurized Pipes under Creep Condition

Creep constraint analysis and constraint parameter solutions for axial semi-elliptical surface cracks in pressurized pipes

Creep constraint analysis and constraint parameter solutions for circumferential surface cracks in pressurized pipes

Creep Constraint and Fracture Parameter C∗ for Axial Semi-Elliptical Surface Cracks with High Aspect Ratio in Pressurized Pipes

A Creep Crack Growth Life Assessment Method for Pressurized Pipes Based on a Two-Parameter Approach

Creep Crack Growth Prediction and Assessment Incorporating Constraint Effect for Pressurized Pipes with Axial Surface Cracks

Load-independent creep constraint analysis and solutions for surface cracks in pressurized pipes

Effects of Creep Properties of Materials on Unified Creep Constraint Parameter Ac for Cracked Pipes

Comparisons of Creep Constraint and Fracture Parameter C* of Different Types of Surface Cracks in Pressurized Pipes

Fracture Assessment Based on Unified Constraint Parameter for Pressurized Pipes with Circumferential Surface Cracks

Prediction of Creep Crack Initiation Behavior Considering Constraint Effects for Cracked Pipes

Three‐dimensional analyses of unified characterization parameter of in‐plane and out‐of‐plane creep constraint

Unified Correlation of Geometry and Material Constraints with Creep Crack Growth Rate of Welded Joints

In-plane and Out-of-plane Unified Constraint-Dependent Creep Crack Growth Rate of 316H Steel

Unified Correlation of In-Plane and Out-of-Plane Creep Constraints with Creep Crack Growth Rate

Unified Characterization of In-Plane and Out-Of-Plane Creep Constraint Based on Crack-Tip Equivalent Creep Strain

Characterization and correlation of 3-D creep constraint between axially cracked pipelines and test specimens

Ductile Fracture Prediction Based on J-integral and Unified Constraint Parameters for Cracked Pipes

Creep constraint analysis for test specimens with a wide range of dimensions and comparison with constraint of cracked pipes

In-plane and Out-of-plane Constraint Characterization of Different Constraint Parameters for Semi-Elliptical Surface Cracks in Pipes

Creep Fracture Parameter C* Solutions for Circumferential Surface Cracks in Pressurized Cylinders