Microstructural Characterization and Mechanical Properties of a Novel TiC-based Cermet Bonded with Ni3(Al,Ti) and NiAl Duplexalloy

Wenqiang Hu,Zhenying Huang,Leping Cai,Cong Lei,Wenbo Yu,Hongxiang Zhai,Shaoshuai Wo,Xinkang Li,Yang Zhou

DOI: https://doi.org/10.1016/j.matchar.2017.11.003

IF: 4.537

2018-01-01

Materials Characterization

Abstract:A novel TiC/Ni3(Al,Ti)-NiAl composite has been designed and synthesized by in-situ reactive hot-pressing a mixture of Ti3AlC2 and Ni powders. After hot-press sintering at 1500°C and 30MPa, almost fully dense composite was obtained and the in-situ formed TiC grains were well-bonded with Ni3(Al,Ti) and NiAl alloys. Due to the nanolaminated structure in Ti3AlC2 materials that weakly bonded Al layers are more prone to be out-diffused from Ti3AlC2 lattice than that of Ti atoms. The deintercalated AlTi atoms would react with Ni to give rise to the formation of Ni3(Al,Ti) and NiAl alloys, and meanwhile a crystal lattice structure transformation happened from hexagonal Ti3AlC2 to cubic lattice TiC. The formation of phases, grains morphologies, sintering behavior and mechanical properties were associated with sintering temperature. The as prepared TiC/Ni3(Al,Ti)-NiAl composite under 1500°C exhibited superior mechanical properties comparing with the counterparts fabricated under 1350°C and 1400°C because of the enhanced microstructures and eliminations of pores. Hardness, flexural strength and fracture toughness of the TiC/Ni3(Al,Ti)-NiAl composite at room temperature were determined as 9.9±0.35 GPa, 665±26 MPa and 10.23±0.4MPa·m1/2, respectively. Interestingly, the flexural strength and fracture toughness increases with temperature rising from 600 to 800°C, the maximum of flexural strength and fracture toughness could reach 775±25 MPa and 11.6±0.4 MPa·m1/2 at 800°C.