Abstract:Nowadays, high-frequency switching power amplifiers (SPA) have been studied widely; bulk of the researches were focused on audio power amplifiers. In active magnetic bearing (AMB) systems, high-frequency electromagnetic excitation caused by rotor imbalance can affect the performance of the SPA, so the traditional SPA cannot meet the requirements of the AMB systems. Therefore, on the premise of ensuring larger power, the frequency of the SPA should be improved to ensure the normal operation of the AMB system. Two-level pulsewidth modulation (PWM) current-mode SPAs are widely used in AMB systems. In order to broaden the bandwidth and to reduce the average steady-state error current, SiC power devices based SPA with a high bus voltage and a high switching frequency was designed. The basic principle and the linearized control model of SPAs are introduced. Then, the duty ratio stability and average steady-state error current of the SPAs are analyzed based on the output ripple current. When the PWM modulator is designed by either the discrete devices or the integrated chips, the critical gains to ensure the duty ratio stability are, respectively, analyzed based on the slope matching and the nonideal characteristic of operational amplifiers. Hence, two methods to reduce the average steady-state error current are proposed, respectively. One is to adjust the offset voltage of triangular carrier for the P controller, the other is to use a proportional integral (PI) controller. The offset adjusting method allows the SPA to achieve better dynamic performance and wider bandwidth. The proportional integral (PI) controller can reduce the average steady-state error current but narrows the bandwidth. Finally, the experiment results are in good agreement with the theoretical analyses.

An Improved Ring Amplifier with Process- and Supply Voltage-Insensitive Dead-Zone

Process Invariant Biasing of Ring Amplifiers Using Deadzone Regulation Circuit

Modeling of the Static and Flowing-Gas Ring-Ld Side-Pumped Alkali Vapor Amplifiers

Design of a Ring-Amplifier Robust Against PVT Variations in Deep-Nanoscale FinFET CMOS

A PVT Compensated Ring VCO with FVC-Assisted Digital Background Calibration

A 24-Ghz Voltage-Combined Stacked Power Amplifier with Current-Sharing Technique in 65-Nm CMOS

Self-Healing Techniques for Robust mm-Wave Power Amplification

Design and optimization of the ring oscillator based injection locked frequency dividers.

A Low- Power CMOS Ring- Based Oscillator Using Current Steering Logic Structure

A Novel Ring Amplifier with Low Common-Mode Voltage Variation and Noise Reduction Using Floating Power Technique.

Analysis on the Stability of Two-Level Current Mode Switching Power Amplifiers

Effective Gain Analysis and Statistic Based Calibration for Ring Amplifier with Robustness to PVT Variation

A Current Steering Logic Based Ring Oscillator For High Stability And Lower Noise Applications

The Investigation of the Substrates Noise Suppression Using Guard Rings in CMOS Technology

Duty Ratio Stability and Average Steady-State Error of Two-Level Current-Mode Wide-Bandwidth Switching Power Amplifiers

Digital Predistortion Technique and Its Development

An Estimable Stability Method Applied to Power Amplifier Design

A Frequency Stabilization Circuit For The Voltage Controlled Ring Oscillator

Loop Compensation Method to Improve Stability of Power Amplifier for Inertial Stick-Slip Driving

Novel Stabilization Method for Eliminating Oscillation in RF CMOS Nonlinear Power Amplifiers

A Distinctive Method of Eliminating Out-Band Instability in Cascaded Active Device System Based on Narrow-Band Attenuation