Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Finite Element Solutions of Cantilever and Fixed Actuator Beams Using Augmented Lagrangian Methods

Analytical model of electrostatic fixed-fixed microbeam for pull-in voltage

Electrostatic-Nonlinear Beam Coupling Problem Solved by Galerkin Spectral Method

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

A Numerically Stable Dynamic Coefficient Method and Its Application in Free Vibration of Partial-Interaction Continuous Composite Beams

Rigid Body Test and Recovery of Nodal Forces for Beam Element in Updated Lagrangian Formulation

Coulomb-actuated microbeams revisited: experimental and numerical modal decomposition of the saddle-node bifurcation

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Coulomb actuated microbeams: A Chebyshev-Edgeworth approach to highly efficient lumped parameter models

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Performance Analysis and Optimization of Lumped Parameters of Electrostatic Actuators for Optical MEMS Switches

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Influence of Micro-Cantilever Geometry and Gap on Pull-in Voltage

Multiflexoelectric Actuation and Control of Beams

Shear Lag Including Axial Balance of Box Beams by Finite Segment Model

Numerical simulation and analysis of an electroactuated beam using a radial basis function

Coupled-field finite element analysis of MEMS compound electrostatic actuator by using the ANSYS software

Experimental Characterization of the static behaviour of microcatntilevers electrostatically actuated

Static and Dynamic Analysis of Electrostatically Actuated Microcantilevers Using the Spectral Element Method

Analysis of Relaxation of Cantilever Beam Based on Euler-Bernoulli Equation