Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Performance Analysis and Optimization of Lumped Parameters of Electrostatic Actuators for Optical MEMS Switches

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Coupled-field finite element analysis of MEMS compound electrostatic actuator by using the ANSYS software

Analysis of a Novel MEMS Electrostatic Comb Actuator for Optical Switching

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Multiflexoelectric Actuation and Control of Beams

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Mechanical Behaviors Research and the Structural Design of a Bipolar Electrostatic Actuation Microbeam Resonator

Electrostatic Comb-Drive Actuator for Mems Relays/Switches with Double-Tilt Comb Fingers and Tilted Parallelogram Beams

Lumped Parameter Modeling and Analysis of Electromagnetic Linear Actuator

Influence of Micro-Cantilever Geometry and Gap on Pull-in Voltage

The Timoshenko Beam Theory based Spectral Finite Element to Analyse Effects of Shear Deformation on Electrostatically Actuated Narrow Thick Clamped Microbeams

Design and Fabrication of a MEMS Electromagnetic Swing-Type Actuator for Optical Switch

Numerical Analysis of Pull-In Voltage for Contact Mems Switches in Switched-Line Phase Shifter Application

A Hybrid Photovoltaic/flexoelectric Actuation Mechanism Applied to Precision Actuation and Vibration Control of Beams

Static and Dynamic Analysis of Electrostatically Actuated Microcantilevers Using the Spectral Element Method

Symmetrical Design And Analysis Of A Novel Mems-Based 1x2 Optical Switch

Experimental Characterization of the static behaviour of microcatntilevers electrostatically actuated

Dynamic Analysis of electrostatically actuated fixed-fixed microbeams with midplane-stretching effects

Coulomb-actuated microbeams revisited: experimental and numerical modal decomposition of the saddle-node bifurcation

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation