Abstract:In order to accurately characterize and evaluate dust particle diffusion in the dynamic tunneling process of a boring machine, this study considers the 31,116 main transport chute heaving face of the Lijiahao coal mine as a case study. A dynamic tunneling model is developed considering the real dynamic tunneling state of the header, to carry out an in-depth analysis of the spatial and temporal evolution of wind flow and dust dispersion in the tunnel under dynamic excavation. In addition, the results were compared against the calculations of a static standard excavation model of a conventional header. Employing CFD analysis accompanied by field measurements, it was highlighted that the dynamic tunneling of the header leads to an increase in the pressure difference and the turbulent kinetic energy at the working face. Moreover, an increase in the number of vortices was reported, and a higher concentration of dust spreads more quickly along the return wind side wall to the return flow area. On the other hand, the high concentration of dust under the standard tunneling model was found to accumulate a lot on the return wind side. Simultaneously, as the distance between the pressurized air outlet and the working face increases, the average wind speed in the vortex-type wind flow area at the front of the tunnel decreases. When t = 60 s, the return flow area expands to a space of 8 m~24 m from the head, and the dust accumulated above the header spreads to the back of the header to form a high concentration dust region of more than 500 mg/m3. It was shown that the range of high-concentration dust clouds in the breathing zone decreases compared to the results of the standard tunneling model. Moreover, the dust concentration in the breathing zone of the driver is significantly lower than that reported by the standard tunneling model. Based on the results of the field test, the average error between the simulated and measured data of the dynamic tunneling model was calculated to be around 6.46%, thus demonstrating the model's capability in describing the real working conditions of the heave tunnel.

Research on suction capacity and dust suppression performance of a reverse circulation air hammer in tunnel drilling

Rock-Breaking Mechanism Study of Axial and Torsional Impact Hammer and Its Application in Deep Wells

Insight into dust control performance of a reverse circulation drill bit using multiphase flow simulation

Experimental investigation and CFD simulation of multiphase flow behavior in air reverse circulation drilling

An experimental study on energy saving potential for cutterhead drive of shield Tunneling machine using variable-speed hydraulic system

Optimum Design of Large-Diameter Reverse Circulation Drill Bit for Drilling Rescue Wells Using Orthogonal Experimental Method and CFD Simulation

Design and application of a dust suppression technology of the forcing air curtain in fully mechanized rock tunnelling faces

Analysis and comparison of airflow-respirable dust control and innovative ventilation environment in drilling construction tunnels

Design and Optimization of a Novel Dust Collection Device for Underground Dry Drilling Based on Numerical Simulation and Field Testing

Simulation and Analysis of a Split Drill Bit for Pneumatic DTH Hammer Percussive Rotary Drilling

CFD-DEM Simulation of Reverse Circulation Pneumatic Cuttings Removal during Coal Seam Drilling

Research on the dust-control technology of a double-wall attached-ring air curtain on an excavation face

Research and development of vortex suction dedusting device based on multi-factor horizontal response surface method

Study of integrated vortex ventilation and dust removal system in mechanized excavation face

Research on dust control technology and numerical simulation of conical guiding air curtain in fully mechanized excavation face

Investigation on the design of atomization device for coal dust suppression in underground roadways

Verisimilar research on the dust movement in the underground tunneling at the roadheader cutterhead dynamic rotation

Research on the Dust Diffusion and Pollution Behaviour of Dynamic Tunneling in Header Excavators Based on Dynamic Mesh Technology and Field Measurement

Experimental and numerical evaluation of the dust suppression efficiency of an innovative vortex pneumatic fog screen dust control device

Characteristics of dust distributions and dust control measures around road-header drivers in mining excavation roadways

Investigation on the cuttings carrying capacity of a novel retractable drill bit used in casing while drilling with air reverse circulation