Abstract:Whichever the application field, every material forming process generates residual stresses on the surface. While they are likely to enhance the aimed properties of the final mechanical part, these stresses may also drastically reduce them and result in early failures. Therefore, understanding the residual stress state remains a major challenge when coating complex parts, especially as most characterization methods at the microscopic scale involve specific sample preparation procedures which may affect the residual stresses field. This work investigates the residual stress state that exists in chromium oxide coatings deposited via Atmospheric Plasma Spray (APS), using two pioneering techniques featuring high spatial resolution: Scanning Microwave Microscopy and Raman MicroSpectroscopy. The first technique combines the measurement of microwave electromagnetic capacities of a Vector Network Analyzer with the subnanometric resolution of an Atomic Force Microscope: it thus enables performing depth investigations at very accurately defined positions of the probe on the surface. The second technique relies on the principle of photons inelastic scattering and involves a laser beam aiming at the material sample: it allows a fine characterization of the microstructure as well as defects and stresses detection via molecular vibratory signatures. The investigation scale is limited here to a few cubic micrometers. Due to the highly localized scales of our investigations, which also depend on the device, the objective of our procedure required that the comparison should be made not on individual points but on definite mapped areas, every spot being analyzed and post-treated one after another, with optimum measuring parameters. Results have been correlated with XRD measurements to cross-check the average amount of stress observed over a wider area.

Internal Stress on Adhesion of Hard Coatings Synthesized by Multi-Arc Ion Plating

Effects of Stress on the Adhesive Behavior of Photoresist

Study on Residual Stress Modulation and Mechanical Properties of Titanium Nitride Coatings

On the Surface and System Performance of Thermally Sprayed Carbide Coatings Produced under Controlled Residual Stresses

Effects of Residual Stresses on Interfacial Adhesion Measurement

The Repeated Spherical Indentation Test: an Efficient Way to Evaluate the Adhesion of Hard Coatings

Analysis on the Residual Stresses in Functionally Gradient ZrO_2/NiCoCrAlY Coatings

X-ray Evaluation on Residual Stresses in Vapor-Deposited Hard Coatings

Influence of Interface Morphology of Transition Layer on the Residual Stresses of Plasma Sprayed ZrC-based Coatings Examined by Finite Element Simulations

Strain-induced Multiscale Structural Changes in Lamellar Thermal Barrier Coatings

Residual stress and bond strength of bioactive gradient coatings plasma-sprayed

Underlying mechanisms of the stress generation in surface coatings

Finite Element Analysis of Stress Field of Thermal Barrier Coating during the Deposition Process

FIB-DIC ring-core measurement of the residual stress on HiPIMS W/Cu and Cr/Cu multilayer thin films

Thermo-mechanical integrity of coatings with residual stress

Effects of coating porosity, thickness and residual stress on stress and fatigue behavior of micro-arc oxidation coated aero Al alloys

Hard and Adherent A-C:H Gradient Coatings by Stress Engineering

Acta Polytechnica

Dissolution Response of Hydroxyapatite Coatings to Residual Stresses

Effects of Deformation Strengthening on Arc-Sprayed Pseudo-Alloy Coating

The effects of substrate temperature on the residual stress for EBPVD