Fabrication of Fe 1.1 Se 0.5 Te 0.5 Bulk by a High Energy Ball Milling Technique

Jixing Liu,Chengshan Li,Shengnan Zhang,Jianqing Feng,Pingxiang Zhang,Lian Zhou
DOI: https://doi.org/10.1016/j.ssc.2017.09.006
IF: 1.934
2017-01-01
Solid State Communications
Abstract:Fe1.1Se0.5Te0.5 superconducting bulks were successfully synthesized by a high energy ball milling (HEBM) aided sintering technique. Two advantages of this new technique have been revealed compared with traditional solid state sintering method. One is greatly increased the density of sintered bulks. It is because the precursor powders with β-Fe(Se, Te) and δ-Fe(Se, Te) were obtained directly by the HEBM process and without formation of liquid Se (and Te), which could avoid the huge volume expansion. The other is the obvious decrease of sintering temperature and dwell time due to the effective shortened length of diffusion paths. The superconducting critical temperature Tc of 14.2K in our sample is comparable with those in previous reports, and further optimization of chemical composition is on the way.
What problem does this paper attempt to address?