Abstract:One of the key challenges to realize a fully integrated transceiver using silicon based processes is the limited output power achievable, especially at millimeter-wave frequencies. Higher output power can be obtained by using various power combining schemes, which typically sum the output power of N identical amplifying stages coherently. Thus to ensure efficient power combining, the input signal must be distributed to all the amplifying stages on the chip with equi-phase and equi-magnitude. While Wilkinson power splitter has been employed for this purpose in the literatures, it becomes bulky and inefficient when N is large, which severely limits the number of outputs that can be combined.In this paper, a network of coupled lambda/2 standing-wave oscillators is employed to distribute the input signal. Proposed formerly for global clock distribution, theoretically, differential signals of equi-frequency, equi-phase, and equi-magnitude can be obtained by taping onto specific points in the network. It should be noted, however, that the network is especially suited for input signal distribution purpose here, since the specific power combining scheme assumes that a grid of N amplifying stages resides on the chip, which matches to the tap points in a perfect way.A 30 GHz prototype network comprised of four coupled lambda/2 standing-wave oscillators using TSMC 0.18 mu m CMOS process has been design. Post-layout simulation results are presented showing that no distinguishable difference in frequency, phase, and amplitude is observed for the multiple output differential signals. The chip has a total area (including pads) of 800 x 990 mu m(2) and has been submitted for fabrication.

Design of Planar Multi-Way Differential Power Division Network Using Double-Sided Parallel Stripline

Compact Rat-Race Coupler with Double-Sided Parallel-Strip Line (DSPSL) for Dual-Band Arbitrary Power Divisions

A Novel Dieletric Slot Stripline Structure for Millimeter Wave Flexible Printed Circuit

Miniaturization of Rat-Race Coupler With Dual-Band Arbitrary Power Divisions Based on Stepped-Impedance Double-Sided Parallel-Strip Line

Input Signal Distribution Using Coupled Lambda/2 Standing-Wave Oscillators For Coherent Power Combining

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

Miniaturised dual-band rat-race coupler based on double-sided parallel stripline

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

Novel Dual-Band Out-of-Phase Power Divider with High Power-Handling Capability

Analysis and Experimental Validation of Power Distribution Network with Multi-slots Parallel-Plane Structure

Analysis of Signal Propagation in High-Speed Differential Signal Lines with Full-Wave Time-Domain Technique

A Novel Reconfigurable Three-Way Power Divider Constructed on Unitary Plane

SIGNAL PROPAGATION IN HIGH SPEED DIFFERENTIAL TRANSMISSION LINE USING PARALLELIZED FINITE-DIFFERENCE TIME-DOMAIN METHOD

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

Novel Planar Compact Coupled-Line Singleended-To-Balanced Power Divider

A Novel Combined Equivalent Networks Analysis for Power and Ground Planes with Narrow Slots

A Novel Unequal Broadband Out-of-Phase Power Divider Using DSPSLs

Novel Design of Dual-Band Unequal Wilkinson Power Divider

A Wideband Balanced-to-Unbalanced Out-of-Phase Power Divider Based on Hybrid Microstrip/Slotline Structure

Design and Measurement of a Six-Way Microwave Power Splitter with Good Phase Consistency

Compact Dual-Band Balanced-to-Unbalanced Filtering Power Divider Design With Extended \textCommon-Mode Suppression Bandwidth