Abstract:In the CBM (Compressed Baryonic Matter) experiment constructed at the Facility for Anti-proton and Ion Research (Fair) at GSI, Darmstadt, Germany, MRPC(Multi-gap Resistive Plate Chamber) is adopted to construct the large TOF (Time-of-Flight) system to achieve an unprecedented precision of hadron identification, benefiting from its good time resolution, relatively high efficiency and low building price. We have developed a kind of double-ended readout strip MRPC. It uses low resistive glass to keep good performance of time resolution under high-rate condition. The differential double stack structure of 2x4 gas gaps help to reduce the required high voltage to half. There are 24 strips on one counter, and each is 270mm long, 7mm wide and the interval is 3mm. Ground is placed onto the MRPC electrode and feed through is carefully designed to match the 100 Ohm impedance of PADI electronics. The prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency and 60ps time resolution is gotten. In order to further examine the performance of the detector working under higher particle flux rate, the prototype has been tested in the 2014 October GSI beam time and 2015 February CERN beam time. In both beam times a relatively high rate of 1 kHz/cm2 was obtained. The calibration is done with CBM ROOT. A couple of corrections has been considered in the calibration and analysis process (including time-walk correction, gain correction, strip alignment correction and velocity correction) to access actual counter performances such as efficiency and time resolution. An efficiency of 97% and time resolution of 48ps are obtained. All these results show that the real-size prototype is fully capable of the requirement of the CBM-TOF, and new designs such as self-sealing are modified into the strip counter prototype to obtain even better performance.

Readout electronics for CBM-TOF super module quality evaluation based on 10 Gbps ethernet

Readout Electronics for CBM-TOF Super Module Quality Evaluation

Readout Method Based on PCIe over Optical Fiber for CBM-TOF Super Module Quality Evaluation

Front - End Data Readout of High Density CBM - TOF Super Module

Data Acquisition Software for CBM-TOF Super Module Quality Control

A distributed data readout method for quality control of CBM-TOF super module detector

Clock and Trigger Distribution for CBM-TOF Quality Evaluation of RPC Super Module Detector Assemblies

The Prototype Design of Integrated Base for PMT with Pulse Digitalization and Readout Electronics

A Prototype of Strip Readout MRPC for CBM-TOF

A Front-End Electronics Prototype Based on Gigabit Ethernet for the ATLAS Small-Strip Thin Gap Chamber

Preliminary Design of Pulse Digitalization and Readout Electronics for CDEX-10

Development and test of a real-size MRPC for CBM-TOF

A High-Density Time-to-Digital Converter Prototype Module for BES III End-Cap TOF Upgrade

Preliminary Design of Readout Electronics for CDEX-10 in CJPL

All in One Integrated Smart Photomultiplier Tube Readout Electronics with Gigabit Ethernet and PoE

A Prototype Design of the Readout Electronics of MRPC Detectors in CEE in HIRFL

Prototype of time digitizing system for BESIII endcap TOF upgrade

Readout Electronics Prototype of TOF Detectors in CEE of HIRFL

A Front-End Electronics Module for Multi-gap Resistive Plate Chambers

Design and application of readout module ZYNQBee with Gigabit Ethernet interface based on ZYNQ

High Rate Time of Flight System for FAIR-CBM