Abstract:The DarkSHINE experiment aims to search for dark photons by measuring the energy loss of the electrons recoiled from fixed-target. Its electromagnetic calorimeter is primarily responsible for accurately reconstructing the energy of the recoil electrons and bremsstrahlung photons. The performance of the electromagnetic calorimeter is crucial, as its energy measurement precision directly determines the sensitivity to the search for dark photons. The DarkSHINE electromagnetic calorimeter uses LYSO crystals to form a fully absorptive electromagnetic calorimeter. It utilizes SiPMs to detect scintillation light in the crystals, and its readout electronics system deduces the deposited energy in the crystals by measuring the number of photoelectric signals generated by the SiPMs. The DarkSHINE electromagnetic calorimeter aims to operate at an event rate of 1-10 MHz, detecting energies ranging from 1 MeV to 1 GeV. To meet the requirements of high energy measurement precision, high event rate, and large dynamic range, we have researched and designed a readout electronics system based on dual-channel high-speed ADCs and a customized DAQ. The front-end amplification part of this system uses low-noise trans-impedance amplifiers to achieve high-precision waveform amplification. It successfully achieves a dynamic range up to a thousandfold through a double-gain readout scheme. The digital part uses 1 GSPS high-speed ADCs to achieve non-dead-time, high-precision waveform digitization. The DAQ part uses JESD204B high-speed serial protocol to read out the signal from ADC, and transmit it to PC software for processing and storage. Test results show a signal-to-noise ratio greater than 66 dBFS and an ENOB greater than 10.6 bits. Energy spectra measurements have been conducted using LYSO crystals and SiPMs, and an energy resolution of 5.96% at the 2.6 MeV gamma peak of Th-232 has been achieved.

Preliminary Design of Readout Electronics for CDEX-10 in CJPL

Preliminary Design of Pulse Digitalization and Readout Electronics for CDEX-10

Prototype of Pulse Digitizer and Readout Electronics for CDEX-10 in CJPL

FADC electronics design for HPGe detector

8-Channel 14-Bit 125mhz FADC Electronics with 1G Ethernet Readout Based on ZYNQ for HPGe Detector

High Performance Readout Module Based on ZYNQ with Giga Ethernet

Design of a triggerless readout electronics system for CDEX-50

Preliminary Design of a Triggerless Readout System for CDEX-100 HPGe Detector Array

Readout System with 2-Channel 8-Bit 1ghz Fadc Based on Rain1000z1 Zynq Module for Crystal Detector

Data Acquisition System for CEPC Vertex Detector Prototype

Design of Giga Bit Ethernet Readout Module Based on ZYNQ for HPGe

Design and application of readout module ZYNQBee with Gigabit Ethernet interface based on ZYNQ

A Multi-Purpose Readout Electronics for CdTe and CZT Detectors for X-Ray Imaging Applications

CDEX Dark Matter Experiment: Status and Prospects

Recent Status and Prospects of CDEX Dark Matter Search at CJPL

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

The DAQ Ssystem and the Experiment Setup of the PMT Test System in CDEX-10

Design of A Low Noise Readout Asic for Cdznte Detector

Design of High-speed readout electronics for the DarkSHINE electromagnetic calorimeter

Prototype of Readout Electronics for GAEA Gamma Spectrometer of Back-n Facility at CSNS

Recent Status and Prospect of Cdex and Cjpl