Abstract:The CDEX (China Dark matter Experiment) is currently in the stage to upgrade to approximately 10 kg HPGe (High Purity Germanium) detectors (CDEX-10) in CJPL (China Jinping Underground Laboratory) and aims to detect the WIMP (Weakly Interacting Massive Particles). Six analog signals and one inhibited signal are outputted from preamplifier by one HPGe detector (∼ 1 kg) of CDEX-10. The analog signals are conditioned with two 6 μs and one 12 μs shaping amplifiers, and three timing amplifiers respectively. The inhibited signal is used for trigger. The analog signals from shaping and timing amplifiers are digitized to obtain energy spectrum and rise-time distribution. The rise-time distribution is used to discriminate surface, bulk, and very bulk events, which can help to supress the background level in dark matter detection. Composed of commercial modules, the previous DAQ (Data Acquisition Systems) is insufficient in discriminating between bulk and very bulk events due to the limited sampling rate (100 MSPS). Besides, as number of channel increases, the system will be simplified by integrating the trigger logic in FPGA (Field Programmable Gate Array). In this paper, a prototype named RAIN4HPGe is designed with pulse digitizer and readout electronics, integrating 14-bit 100 MSPS ADCs (Analog-to-Digital Converters), 12-bit 1 GSPS ADCs, FPGA etc. . The RAIN1000Z1 readout module based on ZYNQ SoC (System on Chip) is used for readout over Gigabit Ethernet. Better energy resolution, e.g. improving from 558 eV to 474 eV @122 keV, can be achieved by RAIN4HPGe compared to previous DAQ (Data Acquisition Systems) with commercial solution. Moreover, the discrimination performance of bulk, and very bulk events has been improved by RAIN4HPGe with 1 GSPS ADC.

FADC electronics design for HPGe detector

8-Channel 14-Bit 125mhz FADC Electronics with 1G Ethernet Readout Based on ZYNQ for HPGe Detector

Combo Fadc Readout System with 8-Channel 14-Bit 100mhz Fadc and 2-Channel 12-Bit 2ghz Fadc for Hpge Detector

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Preliminary Design of Pulse Digitalization and Readout Electronics for CDEX-10

Prototype of Pulse Digitizer and Readout Electronics for CDEX-10 in CJPL

Preliminary Design of Readout Electronics for CDEX-10 in CJPL

Preliminary Design of a Triggerless Readout System for CDEX-100 HPGe Detector Array

Design of a triggerless readout electronics system for CDEX-50

Design and evaluation of a FPGA-ADC prototype for the PET detector based on LYSO Crystals and SiPM arrays

Design of Giga Bit Ethernet Readout Module Based on ZYNQ for HPGe

Data Acquisition System for CEPC Vertex Detector Prototype

A Switched Capacitor Waveform Digitizing ASIC at Cryogenic Temperature for HPGe Detectors

Analysis and Verification of Relation Between Digitizer's Sampling Properties and Energy Resolution of HPGe Detectors

Design of a high-speed multi-channel data acquisition system based on FPGA

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

Development of the Full-Chain Cryogenic Readout Electronics for the Point-Contact HPGe Detectors

The Design of a DAQ System for a GEM Imaging Detector Based on FET Array Readout

Pulse Shape Discrimination and Spectral Performance of an Inverted Coaxial Point Contact HPGe Detector with Sub-Pf Capacitance

Setup of Small Type DAQ System Based on VME Bus and FADC Module

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector